Trieste ED-PR245L User manual

1
Trieste
Instruction Manual
Refrigerator
Model: ED-PR245L

2
Dear customer:
Thank you for buying this refrigerator. To ensure that you get the
best results from your new refrigerator, please take time to read
through the simple instructions in this booklet.
Please ensure that the packing material is disposed of in
accordance with the current environmental requirements.
When disposing of any refrigerator equipment please contact
your local waste disposal department for advice on safe
disposal.
This appliance must be only used for its intended purpose.
INSTALLING YOUR REFRIGERATOR
User should take out the door handle in the plastic bag, and install it into
the door. Then take out the two handle stopples and cover the installed
screws with them. The handle stopple and screw stopple in the plastic
bag can be used when the user wants the door to be opened from left.
UNPACKING YOUR REFRIGERATOR
WARNING: Use two or more people to move refrigerator.
Failure to do so can result in back or other injury.
·Remove tape and any labels from your refrigerator before
using(except the rating label).
To remove any remaining tape or glue, rub the area briskly with
your thumb.
Tape or glue residue can also be easily removed by rubbing a small
amount of liquid dish soap over the adhesive with your fingers.
Wipe with warm water and dry.

3
·Do not use sharp instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or glue. These products can
damage the surface of your refrigerator.
·When moving the refrigerator, do not tilt the refrigerator beyond 45°
from upright position.
CLEANING BEFORE USE
After you remove all of the packaging materials, （especially the foam
between outside condenser and cabinet should be removed）
clean the inside of your refrigerator before using it.
SPACE REQUIREMENTS
WARNING: Keep flammable materials and vapors, such as
gasoline, away form refrigerator.
Failure to do so can result in death, explosion, fine or burns.
·To ensure proper ventilation for your refrigerator, allow for 200mm
space on each side between walls, 100mm space between back of
your refrigerator and the wall, and 300mm space between counter
top and the roof or ceiling.
·If you are installing your refrigerator next to a fixed wall, leave
sufficient space on the hinge side to allow for the door to swing
open.
·Never install your refrigerator near heat source and direct sun shins.
ELECTRICAL REQUIREMENT
WARNING: DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fire or

4
electrical shock.
Before you move your refrigerator into its final location, it is important
to make sure you have the proper electrical connection.
Recommended Earthing Method
A 230 Volt /50 Hz AC only 10 ampere fused and properly earthed
electrical supply is required. It is recommended that a separate circuit
serving only this appliance be provided. Use a receptacle which
cannot be turned off with a switch or pull chain. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, turn the refrigerator control to OFF and then
disconnect the refrigerator from the electrical source. When you are
finished, connect the refrigerator to the electrical source and reset the
control to the desired setting.
LEVELING
If the refrigerator is not leveled during installation. The doors may not
close or seal properly, causing cooling, frost, or moisture problems. It
is very important of the refrigerator to be level in order to function
properly.
To level your refrigerator, you may either turn the level leg clockwise
to raise that side to the refrigerator or turn counter –clockwise to
lower that side.
NOTE: Having someone push against the top of the refrigerator take
some weight off the leveling leg. This makes it easier to adjust the
leveling leg.

5
USING YOUR REFRIGERATOR
To obtain the best possible results form your refrigerator, it is
important that you operate it properly.
Setting the Thermostat controls
Controls for the refrigerator are located at the fop shelf of the
refrigerating compartment. When you first install your refrigerator,
set the Thermostat knob at 3. Give your refrigerator time to cool
down completely before adding food. It is best to wait 24 hours before
adding food.
The thermostat knob controls the temperature. The higher number
setting, the longer the compressor will run to keep the temperature
colder.
When the thermostat control knob is set to OFF, the refrigerator is not
running,
Changing the Light Bulbs
·Unplug refrigerator or disconnect refrigerator from power supply
before you remove the bulb.
·Replace the bulb with 15-watt appliance bulb. Not all bulbs will fit
your refrigerator. Be sure to replace the bulb with one of the same
size and shape.
·plug in refrigerator or reconnect refrigerator to power supply.
Power Interruptions
If the electricity in your house goes off for a shorter period, keep both
doors closed to help foods stay cold.
Fresh Food Storage
Wrap or store food in the refrigerator in airtight and moisture –proof
material.

6
This prevents food odor and taste transfer throughout refrigerator.
·Fruit –wash, let dry and store in refrigerator in
plastic bags or crisper.
·Leafy vegetables- Remove wrapping and trim or tear off
bruised and discolored areas, wash in
cold water and drain. Place in plastic bag
or plastic container and store in crisper.
·Fish –Use fresh fish the same day as purchased.
·Meat –Store most meat in original wrapping as
long as it is airtight and moisture –proof.
Re –wrap if necessary.
·Leftovers –Cover leftovers with plastic wrap or aluminum
foil.
Plastic containers with tight lied can also
be used.
Note: For best performance, leave enough space in the refrigerator
compartment for air to circulate around the packages. Also let enough
room at the front so the door can close tightly.
Defrosting
Refrigerator compartment –Defrosting process is
automatic by thermostat knob
Melted frost flow into drip tray
and automatic evaporating.
·Turn the thermostat knob to set at OFF position and leave open the
door.
·Remove all foods、shelf or transfer to refrigerating compartment.
·Clean and wipe out the melted frost with a cloth.

7
·After defrosting, turn thermostat knob to origin position.
Note: To avoid damaging the refrigerator compartment wall, do not
use any sharp objects to remove the frost.
MAINTAINNG YOUR REFRIGERATOR
The refrigerator should be clean at least once a month to prevent
odors form building up. Wipe up spills immediately.
To clean your refrigerator:
·Unplug it.
·Remove all movable parts from inside, such as shelves and crisper.
Etc.
·Use a clean sponge or soft and a mild detergent in warm water. Do
not use abrasive or harsh cleaners.
·Hand wash, rinse and dry all surfaces thoroughly.
·Do not use cleaning waxes, concentrated detergents, bleaches or
cleaners containing petroleum on plastics and rubber parts.
·Never use paper towels, window sprays, scouring cleansers or
flammable fluids on plastic parts as these can scratch or damage
material.
TROUBLESHOOTING
In case of malfunction, you can solve many common problems easily.
Your refrigerator will not operate…Check if
-- The power supply cord is unplugged.
-- The thermostat knob is set to OFF position.
The light so not work…Check if

8
-- The power supply cord is unplugged.
-- A household fuse or circuit breaker has tripped.
-- A light bulb is loose in the socket.
-- A light bulb has burned out.
Food in the refrigerator compartment freezing…Check if
-- The thermostat knob is set too cold.
-- The position of food stored touches the refrigerant power of
refrigerator back wall.
Food in the refrigerator compartment is not cold…Check if
-- The air vents are blocked in the compartment. This prevents the
movement of cold air.
-- The door(s) are opened too often of not close properly.
-- A large amount of food has just been added to the refrigerator .
-- The position of thermostat knob is adjusted too low.
Melted frost Leak over compartment inside or on floor…Check if
-- The drain –off mouth entrance is blocked.
The refrigerator seems to make unusual noise…Check if
-- The refrigerator is leveled on the floor.
-- The body of the refrigerator touches the wall.
There is interior moisture build - up…Check if
-- The door is opened often.
-- The room is humid.
-- The food is not packaged correctly.
-- The control is not set correctly of the surrounding conditions.

9
The doors will not close completely…Check if
-- Food packages are blocking the door open.
-- The shelves are out of position
-- The gaskets are dirty.
-- The refrigerator is not level.
WARNNING
--the appliance is not intended for use by young children or infirm
persons without supervision.
-- young children should be supervised to ensure that they do not play
with the appliance
--This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
-- Do not use electrical appliances inside the food storage compartments
of the appliance, unless they are of the type recommended by the
manufacturer.
-- Do not damage the refrigerant circuit.
-- Do not use mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the manufacturer.
-- Keep ventilation openings, in the appliance enclosure or in the built-in
structure, clear of obstruction.
-- The instructions shall state that the appliance has to be unplugged
after use and before carrying out user maintenance on the appliance.
-- If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a

10
hazard.
For household refrigerating appliances
Try not to open the door too often, especially when the weather is wet
and hot. Once you open the door, mind to close it as soon as
possible.
Every now and then check if the appliance is sufficiently ventilated
(adequate air circulation behind the appliance).
For household refrigerating appliances, in normal temperature
conditions, please arrange the thermostat at the middle setting.
Before loading the appliance with packages of fresh
foods, make sure they are cooled to ambient temperature.
Ice and frost layer increase energy consumption, so do clean the
appliance as soon as the layer is 3-5 mm thick.
If it is the outer condenser, the rear wall should be always
clean free of dust or any impurities.
Always consider instructions stated in sections Positioning and
Energy Saving Tips, otherwise the energy consumption is
substantially higher.
REQUESTING ASSISTANCE OR SERVICE
If the problem is not due to one of the items listed in
Troubleshooting, Contact the dealer or authorized Service
Company.