True Value BKL01001 User manual

BKL01001
Page 2
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
PARTS LIST DESCRIPTION
A
B
C
D
E
F
G
H
BOLT COVER
HEX BOLT DRIVER
TABLE LEG
LEG CONNECTOR
BRACKET
GLASS TOP
FOOT CAP
FACTORY ASSEMBLY
*NOTE:PARTSSHOWNONPARTSLISTARENOTTOSCALE
Ø6.5 X 1.0 MM
WASHER
Figure 1
Step 4:
Note:
Do not over tighten
After making any necessary adjustments to the
alignment of the table base and table top, use the hex
bolt driver to tighten all bolts. each bolt must
be tightened a few revolutions at a time. In order to
apply equal pressure to all bolt joints, we recommend
working in a cross corner (X fashion). Repeat until
all bolts are tight. . Over
tightening may strip bolts. Cover all bolts with covers.
With the help of another person, turn the table in the
upright position. Note the table bumpers spaced
evenly throughout the inside of the rim. Carefully
place glass inside the rim, resting on the table bumpers.
Your table is now ready for use.
Step 5:
Figure 2
Step 1: Remove all protective materials and set parts on a flat,
non-abrasive surface. Identify parts packed in carton
against the parts list.
Step 2:
Hand tighten only 2-3 turns.
Attach a leg to the leg connector bracket by using a bolt
and washer as shown in . Guide the bolt through
the hole in the leg, leg
connector bracket. Repeat
for the other legs.
F1
into the pre-drilled hole in the
igure
Step 3: Place the table rim upside down on a flat, non-abrasive
surface.
igure
Attach a table leg to the table rim by using two
bolts and washers as shown in . Guide the bolts
through the holes in the table leg into the pre-drilled
holes in the table rim.
Repeat for the other legs.
F2
Hand tighten only2-3 turns.
1/4" X 20 MM BOLT
E
G
F
B
ORDER PART # QTY
1
1
1
4
12
12
12
HW0105
HW0004
HW0006
FC0069
HW0036
TABLE RIM 1
G0199
TABLE BUMPER
FACTORY ASSEMBLY
FOOT CAP
D
C
E
G
F
ST1907
ST1908
ST1909

Page 1
SCOV106
CARE AND MAINTENANCE
SPECIAL WARNINGS!!!
LIMITED WARRANTY
FRAMES
GLASS
GLASS WARNING!
Frames.
Finishes.
Fabrics.
Straps and/or wicker.
Warranty limitations:
Warranty exclusions:
Some states do not allow exclusion or limitation of incidental or consequential damages, so that limitation above may not
apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to
state.
Cleaning
Maintenance
- Use mild soap and warm water. Do not use abrasive materials, cleansers or bleach products. Rinse with clean water
and dry thoroughly.
- Periodically clean and dry thoroughly. Be sure to drain any water accumulated inside the frames. To thoroughly
drain frames, remove foot caps and tilt the frames, if necessary, to remove all water. This is critical. Water allowed to accumulate
inside the frames and then exposed to sub-freezing temperatures can cause damage to the frame tubing. Such damage is not
covered under warranty. Always clean, drain and dry thoroughly before storing for the winter. For best results, always store or
cover your furniture when not in use. We recommend commercially available outdoor furniture covers. Any rust spots should be
lightly sanded, treated with a commercially available rust inhibitor and followed by an application of touch-up paint. Any small
nicks or scratches can be covered with a light application of touch-up paint.
** When cleaning or moving large or heavy items, always have two people work together. Never drag furniture.
Use commercially available glass cleaners. Do not use abrasive materials, cleansers or bleach products.
Tempered glass is engineered to break safely into blunt pieces. However, broken glass pieces may still cause injury. PLEASE
TAKE PRECAUTIONS AND DO NOT ALLOW ANYONE TO CLIMB, STAND, CRAWL OR WALK ON THE TOP OF THE
GLASS TABLE. ALWAYS TAKE PRECAUTIONS TO PROTECT YOUR GLASS TABLE DURING STORMS AND HIGH
WINDS.
Frame construction is warranted against defects in materials or workmanship for one year from purchase date.
Damage to frames or welds resulting from improper assembly or exposure to water and/or sub-freezing temperatures is not
covered. General frame rusting is not covered.
Paint finishes are warranted against peeling, cracking or blistering for one year from purchase date provided the
unit has not been scratched or abraded. Chips and scratches resulting from normal wear and tear are not covered.
Fabric and cushions (if applicable) are warranted against separation at the seams for one year from purchase date.
Fading and/or discoloration resulting from exposure to the elements, oils, spills, fluids, chemicals, or any other cause is not
covered.
Straps and/or wicker weave (if applicable) are warranted against separation and tearing for one year
from purchase date. Fading and/or discoloration resulting from exposure to the elements, oils, spills, fluids, chemicals, or
any other cause is not covered.
This warranty is to the original purchaser only when purchased from one of our authorized dealers and is
not transferable. We will pay shipping and handling charges for replacement items within the North American continent during
the first year of ownership on all valid warranty claims. After the first year, shipping and handling charges are the responsibility
of the claimant/owner. We shall not be responsible for charges associated with shipments outside of the North American
continent at any time.
The following are excluded from coverage under this limited warranty: any item used for commercial,
contract or any other non-residential purpose; clearance items, display models or items purchased "as is"; freight damage; items
subject to misuse, abuse, or lack of proper care or maintenance; damage caused by acts of nature, acts of force majeure,
vandalism, fire or improper assembly; hardware against corrosion or rusting; purchased or replacement parts; and all plastic parts.
Also excluded are loss of use or time; inconveniences; money, travel, packaging or incidental, special or consequential damages
of any kind. Replacement of defective items as provided herein shall constitute the sole and exclusive remedy of the purchaser
for items which are not as warranted. In no event shall our responsibility exceed the purchase price of the item found to be other
than as warranted. This warranty is the exclusive statement of your rights with respect to defects in the items you have purchased
and supersedes any other expressed warranty or statement, written or oral, made in connection with the purchase and sale of those
items. When used herein, the term "item" refers to the specific item found to be defective, and not to the entire set of which the
item is a part.
·
·
·
·
·Umbrellas
Table tops
. Umbrellas (if applicable) are warranted against manufacturer's defects only for one year from purchase date.
Umbrella bases (if applicable) are not covered under any circumstances.
. Natural stone tabletops only are warranted against defects in materials and workmanship only for one year
from purchase date. All table tops (including without limitation glass and faux stone) are not covered under any
circumstances.
·
PATIO FURNITURE & ACCESSORIES
ASSEMBLY INSTRUCTIONS
IMPORTANT!!!
STOP! PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE
ASSEMBLY. MAKE SURE YOU HAVE ALL THE PARTS AND
HARDWARE AS IDENTIFIED ON THE PARTS LIST.