1. Q:
A:
2. Q:
A:
3. Q:
A:
4. Q:
A:
5. Q:
A:
6. Q:
A:
7. Q:
A:
How to turn off the device?
This device has function of intelligent detection, in the case of no load
or the charging completed, it will power off automatically, which could
prevent power loss and make service life longer.
How long does it take to charge this device fully?
It takes 3 - 5 hours to fully charge the device using the 12V/1A or
15V/1A charger our company equipped.
How long can this device charging for the mobile phone?
By adopting the intelligent IC management system, intelligent detection
charging environment and intelligent matching the most secure current
of the digital devices for the intelligent charging, and the maximum
current can reach3A, it takes about 1 - 2 hours to fully charge the phone.
How many times can the device start the vehicles if the power
capacity is 100%?
Depending on different displacement and car motor, the device can
intermittently continuous start the car under 3.0 displacement for over
30 times.
How to maintain the device when not in use?
The recommended temperature setting is 0°C - 40°C, please keep
the device far from liquid, open fire or heating objects, do not storage
the device in a damp place. The storage age is 3 - 6 months, while
please charge the product every 3 month, to prolong the service life.
If the product is not being used after fully charge, how long can
be stored to start the car?
If the products are not being used 3 - 6 months, and product of more
then 50% of the electricity there, you can normally start the car, if
there is 10% electricity left, you can use them for charging the digital
products.
If the device can not start the car, how to solve it?
1) Please check the power capacity of the device and make sure
there are two lights on (50% capacity) which can start the vehicles.
2) Please check the clamps tightly or not and make sure the positive
and negative is not wrongly. The right way is that Red with red and
Black with black after holding tightly which is the positive clamp and
negative clamp of the device respectively connected with the positive
clamp and negative clamp of the vehicles, and connect the EC5
connector with the device, twist-off the car keys to start the car one
time. If the startup failed, please wait a few seconds before the re-start
operations. If the start-up is successful, please quickly disconnect the
clamps from the vehicle’s battery to the device, then please remove the
clamps from the vehicle’s battery.
3) Please check the vehicle’s battery if it is under charge or not, if yes,
please follow step 2 to start the vehicle and the vehicle’s battery will
be automatically charged.
Frequently Asked Questions (FAQ):
8
