UllMann MAX FALCON User manual

MAX
WING MANUAL
FALCON
MAX

MAX
1
Ullman Windsports 2022 ©

2
Ullman Windsports 2022 ©
THE WING | MAX
RELEASES & AGREEMENTS
RELEASE OF LIABILITY, CLAIM WAIVER AND ASSUMPTION OF RISK AGREEMENT
RELEASE AND WAIVER OF CLAIMS AGREEMENT
In consideraon of your use of this product, you hereby agree to the following, to the fullest extent permied by
law: To waive any and all claims that you have or may have in the future against Ullman Wingsurifng Internaonal,
a division of Airscape PTY Ltd , or any of its agents, resulng from use of this product and any of its components.
Ullman Wingsurifng Internaonal, a division ofM Airscape PTY. Ltd, or any of its agents from any and all liability
for any loss, damage, injury or expense that you or any users of this product may suer, or that your next of kin
may suer, as a result of the use of this product, due to any cause whatsoever, including negligence or breach
of contract on the part of Ullman Wingsurifng Internaonal, a division of Airscape PTY Ltd, or any of its agents,
in the design or manufacture of this product.
BINDING EFFECT OF AGREEMENT
In the event of your death or incapacity, this Agreement shall be eecve and binding upon your heirs, next of
kin, executors, administrators, assignees and representaves.
ENTIRE AGREEMENT
In entering into this Agreement, you are not relying upon any oral or wrien representaons other than what is
set forth in this agreement and User’s Guide.
BY INFLATING THE LEADING EDGE AND ASSEMBLING THIS PRODUCT, YOU ARE AGREEING TO:
1) be bound to the terms set forth below and 2) require anyone using this product to be bound by such terms.
If you are unwilling to be bound by these terms, return this product (before use) for a full refund.
ASSUMPTION OF RISK
Use of this product and any of its components involves certain inherent risks, dangers and hazards, which can
result in serious personal injury and death. In using this product you freely agree to assume and accept any and
all known and unknown risks of injury while using this equipment. The risks inherent in the sport can be greatly
reduced by abiding by the Warnings and Guidelines listed in this User’s Guide and by using common sense.

3
Ullman Windsports 2022 ©
THE WING | MAX
LETS FAMILIARIZE OURSELVES
WITH THE BASIC TERMS FIRST
1 Leading Edge
2 Strut
3 Wing Tip
4 Trailing Edge
5 Progression Bar
6 Back Bar Holder
7 Safety Leash & Handle
1
2
6
3
4
7
THE WIND RANGES ARE EXPRESSED IN KNOTS AND THE SIZES IN ACTUALSQUARE METERS.
THIS WIND RANGE IS GIVEN TO YOU AS AN INDICATION FOR ARIDER WEIGHTING 75 KG.
WIND RANGE VARIES ACCORDING TO EACH RIDER. IT DEPENDS ON:
• The rider’s level: the more you progress the more you will be able to use the wing in the upper wind range.
• The rider’s weight: the bigger you are the more you will be able to use the wing in the upper wind range.
• The type of board used: SUP, SUP foil or Surf foil. You also must choose your wing according to: the aerological
situaon (the airow quality), the weather condions (wind direcon, speed, forecast), and the overall quality of
the spot and the level of safety it oers. When you get to the spot, measure up the wind speed.
5

4
Ullman Windsports 2022 ©
THE WING | MAX
Bft Km/H Knots Description
00 <1 <1 Calm, smoke raises vercally
01 1-5 1-3 Light air
02 6-11 4-6 Gentle breeze.
03 12-19 7-10 Flags extended.
04 20-28 11-16 First white caps appear
05 29-38 17-21 Trees begin to sway.
06 39-49 22-27 Sand blows on the beach.
07 50-61 28-33 The white caps are all over
08 62-74 34-40 Resistance felt in walking
against wind.
09 75-88 41-47 Watch the power of nature.
10+ >89 >48 Stay home!
WIND TABLE
-The wind table is indicave and should not be see as a absolute.

5
Ullman Windsports 2022 ©
THE BAR | MAX
BAR INSTALLATION
This bar is manufactured out of carbon tubes with a stainless steel push pin. We will always recommend rinsing
it with fresh water aer use and storing it in a dry place. Please note the bar is to be installed before you inate
the wing. Assemble the wing in the sequence
1. Bar on to wing
 2.Inatethestruttomaximumpressure8.5psi
 3.Inateleadingedgetomaximum8.5psi
When inang , we recommend not to use compressed air and to stop at least once when pumping. This allows
the pressure ll the bladders evenly.
STEP 1
The rst step , place the wing on to
beach or lawn. Open the Neopren
pocket by pulling on the yellow tab.
Please Note : assemble bar before
inatinginatingwing

6
Ullman Windsports 2022 ©
THE BAR | MAX
STEP 2
Insert the le side of the T-shaped
head peace underneath the Dynema
webbing strap. Push as far as possible
to the le.
STEP 3
Slowly , turn the bar to the le side at
about 45 deg . Slowly insert the right
side of the T-shaped under neath the
Dynema webbing. Please note this
mightbeatightwhenthewingisnew.
Once installed it will sll move loosely
underneath that straps. The Pressure
of the inated leading edge will secure
the T-Shape.
STEP 4
Now take the backend of the bar and
insert the bar underneath the rst
webbing strap. Push the bar unl ,
the Securing rope aliens with the loos
webbing strap and buckle.Pleasenote
thestrapwillbetightwhennew

7
Ullman Windsports 2022 ©
THE BAR | MAX
STEP 5
Now , insert the loos webbing strap
form le to right through the slot in
the bar . Once inserted pull though and
fasten the webbing strap. Do not pull
thestraptight. The webbing needs to
have some slack allow for the strut to
expand when inang.
STEP 6
Now take the cover strap and aach
to the Velcro on le . Now your wing is
ready for inaon .
STEP 7
Now your wing is ready for inaon : First inate the strut , then inate the leading edge. When inang always
briey pause. Allowing the Bladders to move into posion before nal pressure is achived .

8
Ullman Windsports 2022 ©
WING HANDLING | MAX
INFLATION
DEFLATION
A B C
FED
G H I
J

INFLATION
A) Lay the wing at on the ground with the strut facing up. Making sure the leading edge is facing the wind. Also
consider the surface, hard ground can damage the wing. Ideally grass or beach sand.
B) Aach Pump leash to the Hand Leash connecon, and make sure it is well secured.
C) Open the Valve Cape, rst the Protector and then the Stop Plug. Turn ant clock wise to Open.
D) Push the Valve Stem to the release out the upper open posion, in order to acvate the non return valve.
E) Insert Pump Fing , turn to the right to secure. Start pumping , when approximately 1/2 inated stop for at
least 30 seconds allowing the pressure to equalize between strut and leading edge. Inate the wing to 8 PSI ,
DONOTOVERINFLATE the wing
F) Once the wing is inated and the 8 Psi have been reached. Remove the pump and insert the Valve Cape and
close the Neoprene cape. Now you wing is ready. Please note never leave you wing unaended and unsecured.
DEFLATION
G) In order to deate the wing, remove the valve cap. Push the red valve buon inwards. This will release the
pressure. Keep the buon at the boom , in the open posion.
H & I ) Once the pressure and the air is evacuated, role up the wing from side to side. Preferably on a lawn to
ensure sand or other foreign objects do not end up in or on the wing.
J ) Fold the wing in half and insert it into the bag, being carefull not to bend the baons.
9
Ullman Windsports 2022 ©
WING HANDLING | MAX
NOTE
- Do NOT store wing wet
- Remove foreign bodies e.g. sand / stones from wing before storing.
- Always secure wing once inated ulizing the Hand leash before and aer water me.