unibelus BV-A10 Operator's manual

Quick Operating Guide
BV-A10

1. Component description:
Front view
Rear view

2. Basic operation:
Power on/off
Long press the POWER key [ ] to switch on body worn camera. The status indicator is lit
in green (when the status indicator is activated). To switch off the body worn camera, press
and hold the POWER key for 2s in the power-on state.
NOTE: Please calibrate the time before using the body worn camera with supplied PC tool.
Video recording function
After the body worn camera is switched on, press the video recording key to start audio &
video recording. Press the key again, it will stop taking video recording.
One-key operation
While BWC is in power-off state, long press the video recording key for seconds to switch
on the body worn camera and start video recording automatically.
Infrared night vision
The infrared lamp will be activated automatically according to the ambient brightness.
3. Software usage
After the driver is installed correctly, the body worn camera is ready for use. (For detailed
installation steps and instructions on the software, please refer to the operation manual
contained in the CD.)
4. Charging
Charging with charging station and adapter: insert the BWC into the charging station and
connect the station with the power adapter. Then the status indicator in BWC and charging
station are both lit and the body worn camera is in the charging state. The status indicator
extinguishes once the recorder is fully charged.

Note: 1. It is recommended to charge the body worn camera always in the power-off
state.
2. If the body worn camera is not used for a long time, charge it once fully every 3
months in order to prevent battery failure.