Unicol VCC1 User manual

WARNING
Please carefully inspect the product before assembling. If you notice any apparent damage, call your carrier
claims agent and do not continue the installation until it has been reviewed. Please watch for pinch points.
Do not put your fingers between moveable parts. Do not tamper with or disassemble any spring loaded
parts. Before installing, make sure that the supporting surface will support five times the combined load of
the solution and the hardware. Never exceed the maximum load capacity. Please also layout all components
to ensure that you have all of the required parts before proceeding (see BOM list on following page). Use of
this product for anything other than its specified use may result in failure or personal injury. This product is
intended for indoor use only. We recommend using a qualified trades person for installation. Use an assistant
or lifting equipment to lift and position products.
For support, please call: [phone] or email: [e-mail]
Revised 28/09/22
01865 767676
[e-mail]
www.unicol.com
*Please check model specific details before installing*
Pillar Clamps - VCC1 & VCC2
Screen Size: 70” Guide Max. Weight: 120kg
VCC1 VCC2

2Revised 28/09/22
COMPONENTS
01865 767676
[e-mail]
www.unicol.com
INSTALLERS REQUIRED
1-2
#TOOLS REQUIRED
117mm Spanner
2
3
4
5
1 2
# EQUIPMENT QTY
1Straps 2
2Connecting Bars 4
3Studding with Fixings 4
4Fixing Cover VCC1 (VCC2) 1 (0)
5Fixing Cover with Arm VCC1 (VCC2) 1 (2)
3
45
NOTE: Each VCC is custom made to fit the pillar
specified and once tightened clamp it in position.
There is no need to drill into the pillar.
Multi-arm units are assembled in the same way.

01865 767676
[e-mail]
www.unicol.com
3
Revised 28/09/22
STEP 1 – Place both straps around your pillar, either on the floor or on a support. Place connecting bars
into slots in straps and push the studding provided through the holes to attach them. NOTE: The open
channel section of the bar must be positioned against the wall of the strap.
STEP 2 – Fix the studding together loosely using the plain and split washers and M10 nuts.
Plain Washer
Split Washer
M10 Nut

4Revised 28/09/22
01865 767676
[e-mail]
www.unicol.com
STEP 3 – Fix covers (loosely) to the Strap connecting bars with the 4 x M10 x 25 hex screws provided. Lift
the whole unit to the desired height and tighten studding so that it clamps the straps to the pillar. Tighten
cover screws. The VCC1 has an arm on one cover only. The VCC2 has arms on both covers.
STEP 4 – Connect direct fitting adapter (ordered separately) to peg for screen or projector suspension.
A through bolt (supplied with the adapter) must be used to connect the adapter to the peg. Take up any
slack using the grub screws in the adapter socket.
PS1 Screen
Adapter shown