Unicol TVV1 User manual

WARNING
Please carefully inspect the product before assembling. If you notice any apparent damage, call your
carrier claims agent and do not continue the installation until it has been reviewed. Please watch for
pinch points. Do not put your fingers between moveable parts. Do not tamper with or disassemble any
spring loaded parts. Before installing, make sure that the supporting surface will support five times the
combined load of the solution and the hardware. Never exceed the maximum load capacity. Please also
layout all components to ensure that you have all of the required parts before proceeding (see BOM list
on following page). Use of this product for anything other than its specified use may result in failure or
personal injury. This product is intended for indoor use only. We recommend using a qualified trades
person for installation. Use an assistant or lifting equipment to lift and position products.
For support, please call: [phone] or email: [email protected]
Revised 15/12/20
01865 767676
[email protected]
www.unicol.com
*Please check model specific details before installing*
TVV1 / TVL1 / TVT1 / TVB1
Screen Size: 15-40” Guide Max. Weight: 15kg

01865 767676
[email protected]
www.unicol.com
2Revised 15/12/20
COMPONENTS
INSTALLERS REQUIRED
1-2
# DESCRIPTION QTY
11000mm Column 1
2Single Column VESA Mount 1
3Tevella Base 1
4Column Support Ring 1
5 Alternative Bases -
#TOOLS REQUIRED
1 3/16th Allen Key
2 5mm Allen Key
1
2
34
5

01865 767676
[email protected]
www.unicol.com
3
Revised 15/12/20
STEP 1
Check the jaws of the column grip, if you can push
them together to fit a column over, ignore this step.
If you can’t, you will need to loosen the screw on
the column grip to close them.
Thread cabling through bottom of base into column
grips as highlighted above.
STEP 2
Place the column support ring over the crocodile
lug with the straight edge facing the rear of the
base (as shown above).
Thread the cabling through the column and place
the column with holes, located approx 75mm from
the bottom, over the crocodile lugs on the base.
STEP 3
Once placed, tighten the grub screw to secure into
place.
STEP 4
Locate the mounting holes on the back of your
screen. Line the VESA mount up and using the
manufacturer recommended screws, attach the
mount to the back of the screen.

4
01865 767676
[email protected]
www.unicol.com
Revised 15/12/20
STEP 5
Slide the mount and adapter over the column and
position at the desired height. When happy, tighten
the grub screw to secure the mount and screen into
position.
STEP 6
Loosen the screws at the side of the mount to set
the angle of the screen. Once in position, retighten
the screws.
STEP 1
Position floor plate and mark through the screw
holes (arrows above) where it will be positioned.
Before you screw through, ensure any cables
that are going underneath the plate are threaded
through the column grips (circled above). Continue
with Step 2.
STEP 1
Before you begin, make sure the base is stable and
ensure the brakes are on on the front two castors.
Loosen the screws on the column grips to close
them.
Thread cabling through bottom of base into column
grips as highlighted above. Continue with Step 2.
BOLT DOWN TROLLEY