Unicol PA2 User manual

WARNING
Please carefully inspect the product before assembling. If you notice any apparent damage, call your
carrier claims agent and do not continue the installation until it has been reviewed. Please watch for
pinch points. Do not put your fingers between moveable parts. Do not tamper with or disassemble any
spring loaded parts. Before installing, make sure that the supporting surface will support five times the
combined load of the solution and the hardware. Never exceed the maximum load capacity. Please also
layout all components to ensure that you have all of the required parts before proceeding (see BOM list
on following page). Use of this product for anything other than its specified use may result in failure or
personal injury. This product is intended for indoor use only. We recommend using a qualified trades
person for installation. Use an assistant or lifting equipment to lift and position products.
For support, please call: [phone] or email: [email protected]
Revised 15/12/20
01865 767676
[email protected]
www.unicol.com
*Please check model specific details before installing*
PA2 / PA9
Screen Size: 40-80” Guide Max. Weight: 80kg

01865 767676
[email protected]
www.unicol.com
2Revised 15/12/20
COMPONENTS
INSTALLERS REQUIRED
1-2
# DESCRIPTION QTY
1Parabella Base 1
2C15230 Mounting Plate 1
3Mount Back Plate 1
4Mount Arms 2
5Parabella Legs 2
6M12x25 Button Head Screws 8
7M10x20 Hex Head Screws 4
#TOOLS REQUIRED
1 8mm Allen Key
2 Pozi Head Screwdriver
3 17mm Spanner
12
3
4
5

01865 767676
[email protected]
www.unicol.com
3
Revised 15/12/20
STEP 1
The unit is supplied with a power cable with a kettle
plug & socket along its length. Use this to thread
the cabling down the Parabella’s legs and through
the base.
STEP 2
With legs laying on a flat surface (as shown above)
pick up the base with the help of another person
and offer the base to the mast. Ensure fixing holes
are aligned and then secure.
STEP 3
Fix the C15230 mounting plate to the top of the
legs using M12x25 screws.
STEP 4
Line the back plate up with the mounting plate,
as shown above. Fix 4 M10x20 screws from behind
the mount adapter and into the 4 rivet nuts located
on the back plate. Ensure back plate is secure and
screws are tightened.

4
01865 767676
[email protected]
www.unicol.com
Revised 15/12/20
STEP 5
Utilising the tag locks and fixing pack provided with
your mount, attach the arms to the back of your
screen.
Ensure the arms are the correct way up before
tightening - the ‘hook’ part of the arm should be at
the top.
STEP 6
Using another team member, lift the screen up and
gradually offer it up to the back plate. Gently tilting
the screen forward, hook the arms over the lip of
the back plate and lower once in position.
Centre the screen horizontally by sliding from side
to side until you are happy with the position.
STEP 7
Once centered, ensure the bottom screws are not
screwed tight and screw down the top screws to
level the screen. Once level tighten bottom screws
to secure the mount. ALT: If using tilting arms, this
is when you can adjust them to suit.
Note that you won’t be able to adjust the screens
position after the screws have been tightened.
STEP 8 [OPTIONAL]
To fitting a shelf, angle it as you offer it up to the
stand to allow the rear clips to fit between the legs.
Level out and lower into position, ensuring both
sides securely slot into place.