USA Industries EZ-LOCK BLIND RACK User manual

EZ-LOCK BLIND RACK®
OPERATING MANUAL
www.USAIndustries.com [phone] • [phone]
315 State Street • S. Houston, TX 77587
INDUSTRIES
M-PIP-EZLBR-OM-1.3
U.S. Patent 9,546,889 - January 17, 2017

EZ-LOCK BLIND RACK®OPERATING MANUAL www.USAIndustries.com | [phone]
©2022, USA Industries
M-PIP-EZLBR-OM-1.3
EZ-LOCK BLIND RACK®
OPERATING INSTRUCTIONS
LOADING & UNLOADING
BLINDS
Raise the door upward using the
door handle. When the door is
raised and rotated upward, the weight
of the latch will cause the Latch to fall
freely to the position shown, allowing
the door to remain safely open.
1
LATCH
Move the Retainer Plate to the
position shown in this image,
allowing free travel of the blinds onto
the rack. Note that the Retainer Key
is rotated to a desired position. The
Vertical Pin restricts the operator
from removing the Retainer Plate.
2RETAINER PLATE
Insert blinds between the
Hangers one at a time as shown.
The Retainer is positioned and pushed
as far back as possible securing the
blinds in place and restricting their
travel. The Retainer Key is then
rotated to the nearest slot in the
Indexing Plate.
3
BLINDS
INDEXING PLATE
DO NOT exceed the safe load limit of 12,000 lbs.
Ensure that the key is properly inserted in the indexing plate slot to prevent
movement of blinds

EZ-LOCK BLIND RACK®OPERATING MANUAL www.USAIndustries.com | [phone]
©2022, USA Industries
M-PIP-EZLBR-OM-1.3
EZ-LOCK BLIND RACK®
OPERATING INSTRUCTIONS
LOADING &
UNLOADING BLINDS
TRANSPORTING R ACK
With one hand held firmly on the
door handle, raise the Latch to the
top flange of the door. Now, slowly
and steadily lower the door until the it
aligns with the hole on the door stop.
4
When the door is closed, rotation of the Retainer
Key is restricted. The Blinds are locked in place
and cannot be removed without removing the
Pad-Lock and rotating the Retainer Key out of
the Indexing Slot.
• Use the lifting lugs provided on
the top, if using crane for moving or
transporting the rack.
• Use the fork lift skids provided
on the bottom, if using fork lifts to
move or transport the rack.
5
INDEXING PLATE
LIFTING LUGS
INDEXING
PLATE WITH
SLOTS
FORK LIFT SKIDS
Use extra care while raising the
latch.
DO NOT place hands under the
door while closing. Severe injury
may occur.

EZ-LOCK BLIND RACK®OPERATING MANUAL www.USAIndustries.com | [phone]
©2022, USA Industries
M-PIP-EZLBR-OM-1.3
EZ-LOCK BLIND RACK®
OPERATING INSTRUCTIONS
TRANSPORTING
STRAPS
Extra Care must be taken while transporting the rack as shown. DO NOT strap the rack
without the pad lock or a secure form of locking straps in place as in the figure at the
bottom of this page. This would otherwise result in misalignment of the door.
SECURE LOCKING STRAPS
OR PAD LOCK