
10
10
GETTING STARTED
When you use Kidizoom®Action Cam
HD for the rst time, you will need to
switch the master power switch to on.
Locate the master power switch on the
bottom of the camera, then move it to the
1 position .
When the camera is switched off, it will
not be possible to charge the camera or
play any activities.
Note: It is not necessary to move the switch to off in daily use. Only
move the switch to off when the camera isn’t in use for an extended
period of time.
Wrist Strap must be removed from the Action Cam HD before
putting into the waterproof case to avoid water leaking!
BATTERY RECHARGING
Note: Adult operation required.
• Connect the camera to a computer with the included micro-USB
cable for battery recharging.
• Make sure the master power switch is turned on before recharging.
• Pull up the rubber cover of the micro-USB port at the side of the
camera.
• Insert the micro-USB cable (small end) into the micro-USB port on
the camera.
• Insert the large end of the micro-USB cable into a USB port on the
computer. A USB port is usually marked with this symbol:
• Once the connection is successful, you will see the battery recharging
symbol on the camera screen.
• Check on your camera regularly throughout recharging.
• When the battery is fully charged, a message will be displayed on
the screen for a while, then the screen will turn off. Disconnect the
camera from the computer.
Note: It will take approximately 3 hours to fully charge the battery. The
actual charging time depends on the charging current, the remaining
charge and the ambient temperature of the charging environment. The
optimum ambient temperature is 32°F - 104°F (0°C to 40°C).