Vauxhall 2013 Corsa Infotainment system User manual

Corsa
Refer to Owner’s Manual for detailed information. Note: some items described may be optional 3.
Quick Reference Guide
August 2007
TS 1652-A-08
Vehicle security
Manual window operation:
The door windows can be operated
using the crank.
Refuelling:
Open tank flap, unscrew fuel filler cap,
remove and suspend from tank flap. The
fuel tank has a limiting system which
prevents overfilling of the tank.
Electric windows on the front doors 3:
Operated via two switches in the driver’s
door armrest. An additional switch is
located in the passenger’s door.
For incremental operation, briefly pull or
press the switch. For automatic opening
or closing, pull or press switch for longer.
Pull or press the switch again to stop the
movement.
Unlocking and opening luggage
compartment:
Turn the key in the driver’s door lock
towards the front of the vehicle - or -
press button qon the remote control 3.
The luggage compartment is unlocked
together with the doors and can be
opened by operating the button
beneath the lever.
Instruments and controls
If the driver’s door is not closed properly,
the central locking system will not lock.
The doors can be opened from the
inside by pulling the handle, even when
the central locking system is locked.
Locked doors will automatically unlock
in the event of an accident of a certain
severity.
Electronic immobiliser:
zDeactivated with key in starter switch.
zActivated when key is removed.
Engine cannot be started in any other
way, so keep spare key in a safe place!
Starting the engine:
Manual transmission in neutral with
clutch and brake pedals depressed,
automatic transmission 3 in Por N,
Easytronic 3in N,do not accelerate,
(diesel engines; turn key to 2, wait until
preheating control indicator !
extinguishes), turn key to 3; release key
when engine is running.
Releasing the handbrake:
Raise lever slightly, press release button,
lower lever fully.
1. Side ai r vents
2. Front passenger’s airbag
3. Heated front seats 3,heated steering
wheel 3, Deflation Detection
System 3, central locking button,
hazard warning lights, front
passenger’s airbag system
deactivation, parking distance
sensors 3, Electronic Stability
Programme 3
4. Display for time, date, outside
temperature, Infotainment system 3,
check control 3, trip computer 3,
Electronic Climate Control 3
5. Centre air vents
6. Turn signals, headlight flash,
dipped beam, main beam,
door-to-door lighting 3,
parking lights 3,cruise control 3
7. Steering wheel remote control 3
8. Instruments
9. Horn, driver’s airbag
10. Windscreen wiper and wash system,
rear window wiper and wash system,
trip computer 3
11. Parking lights, dipped beam,
instrument illumination, fog tail light,
front fog lights 3, headlight range
adjustment 3
12. Starter switch with steering column
lock
13. Accelerator pedal
14. Brake pedal
15. Clutch pedal 3
16. Steering wheel adjustment
17. Ash t r ay
18. Accessory socket 3, cigarette lighter 3
19. Climate control
20. Infotainment system 3
21. Glove compartment
22. Bonnet release
Unlocking:
Press button qon remote control - or -
turn key in driver's door lock towards
front of vehicle as far as it will go, turn
key back to the vertical position and
remove.
To unlock from inside, press central
locking button min the centre console.
Locking:
Press button p on remote control - or -
turn key in driver's door lock towards
rear of vehicle as far as it will go, turn key
back to the vertical position and
remove. To unlock from inside, press
central locking button min the centre
console with the doors closed. LED in the
button illuminates.
Tyre pressures in psi
for loads of up to 3 persons,
(Petrol engines)
Hatchback, Corsavan
Engine Tyres Front Rear
Z 10 XEP All tyres 29 26
Z 12 XEP All tyres 29 26
Z 14 XEP All tyres 29 26
Z 16 LEL,
Z 16 LER
All except below 35 35
225/35 ZR 181)
1) Not in vehicles with Z 16 LEL engine.
38 35
Refuelling continued:
Before refuelling, switch off engine and,
if applicable, any auxiliary heating with
combustion chambers. Switch off mobile
phones.
To close, position fuel filler cap and
rotate past resistance until cap audibly
engages. Lock cap with ignition key 3.
Close tank flap and wipe off any
overflowing fuel.
Petrol engines - use unleaded fuel only.
Diesel engines - use diesel fuel meeting
specifications of DIN EN 590.
Fuel tank capacity (all models) - 45 litres.
Engine oil:
Check every 300 miles or prior to long
journeys.
Important:
It is the owner’s responsibility to
maintain the correct level of an
appropriate quality oil in the engine.
Closing and locking luggage
compartment:
Close luggage compartment using
handle on the inside of the tailgate.
Turn key in driver’s door lock towards
rear of vehicle - or - press button pon
the remote control 3 to lock.
Bonnet:
To open bonnet, pull the release lever
located below the instrument panel. The
bonnet will then be unlocked and will
partially open. Return release lever to its
original position.
To open completely, locate safety catch
on underside of bonnet: lift this upwards
and open the bonnet. Insert support
located in front of battery in catch
above bonnet hinge. To close, hold
bonnet, release support and press it
back into its bracket.
Automatic transmission 3:
The engine can be started only in Por N.
To move out of P, switch on ignition,
depress footbrake and press button on
selector lever. To engage Por R, press
button on selector lever.
P: Only with vehicle stationary,
first apply handbrake.
R: Only with vehicle stationary.
Easytronic transmission 3:
The engine can be started only with the
footbrake depressed. The current gear is
displayed in the transmission display.
Move selector lever towards Ato switch
to Manual mode, then towards + or -
to shift to a higher or lower gear.
Move lever back to Ato switch back to
automatic gearshifting.
Easytronic Winter programme 3:
When starting-off on slippery roads,
press button T("A" and Tappear in
the transmission display), Easytronic
switches to Automatic mode and the
vehicle sets off in second gear.
Press button Tagain or switch off
ignition to deactivate the Winter
programme.
Tyre pressures in psi
for loads of up to 3 persons,
(Diesel engines)
Hatchback, Corsavan
Engine Tyres Front Rear
Z 13 DTJ All except below 29 26
185/60 R 151)
1) Only approved as winter tyres.
32 26
Z 13 DTH All except below 32 29
185/60 R 151) 35 29
Z 17 DTR All except below 35 32
185/60 R 151) 38 32
Tyre pressures in psi
for full loads
Hatchback, Corsavan
Engine Tyres Front Rear
All engines All except
below
38 46
225/35 ZR1)
1) Z 16 LER only.
41 46
Manual transmission:
Reverse gear: with the vehicle
stationary, 3 seconds after depressing
clutch pedal pull up the button on the
selector lever and engage the gear.

Vehicle features Vehicle features Vehicle features
Light switch (continued):
AUTO Automatic dipped beam
activation 3
kInstrument illumination
qHeadlight range adjustment 3
Correct adjustment of the headlight
range reduces dazzle for other road
users:
zFront seats occupied = 0
zAll seats occupied = 1
zAll seats occupied and
luggage compartment load = 2
zDriver’s seat occupied and
luggage compartment load = 3
Seat adjustment:
To adjust seat position, pull handle at
front of seat, slide seat and release
handle.
Important:Do not sit nearer than
10 inches (25 cm) from steering wheel,
to permit safe airbag deployment.
Adjust backrests:
Turn handwheel on outboard side of
seat. Do not lean on seat backrest whilst
adjusting it.
Move backrest to suit seating position.
Adjust height of seat 3:
Operate lever on outboard side of seat.
Pump action of lever:
Upwards = Raises seat
Downwards = Lowers seat
Folding the backrest forwards 3:
Raise release lever, fold backrest
forwards, lower lever and the backrest
engages in lowered position. Slide seat
forwards.
To raise seat, slide seat back to original
position, raise release lever, move
backrest upright, lower lever and the
backrest engages in upright position.
Seat position:
Adjust driver’s seat such that, with the
driver sitting upright, the steering wheel
is held in the area of its upper spokes
with the driver’s arms slightly bent.
Push front passenger’s seat as far back
as possible.
Adjusting head restraint height:
Press button on side of head restraint
and adjust height.
The middle of the head restraint should
be at eye level.
Fitting seat belts (continued):
Pull smoothly from inertia reel, guide
over shoulder and engage in buckle.
Belt must not be twisted at any point.
The lap belt must fit snugly across the
body.
The seat backrest must not be inclined
too far back (approx. 25° max.). To
release belt, press red button on belt
buckle.
Exterior mirrors
Setting with four-way switch in version
with manual window operation:
Push toggle switch to left or right:
four-way switch moves the
corresponding mirror.
Exterior mirrors
Setting with four-way switch in version
with electric windows 3:
Push toggle switch to left (L) or right (R):
four-way switch moves the
corresponding mirror.
Interior mirror:
Swivel mirror housing to adjust.
To reduce dazzle at night, swivel lever
on the underside of the mirror housing.
Light switch:
0 Off
8Parking lights
9Dipped or main beam
>Front fog lights 3(press)
r Fog tail light (press)
Headlight range adjustment q 3:
With dipped beam switched on, adjust
headlight range in four stages to suit
vehicle load.
Press adjustment buttons until the
correct setting is displayed in the
odometer display.
Fog lights:
Front fog lights 3:
Press >,>illuminates in instrument
panel. Press again to turn off.
Fog tail light:
Press r, rilluminates in instrument
panel. Press again to turn off.
Ignition must be switched on and light
switch in position 9 or 8.
Door-to-door lighting 3:
Turn key to 0and remove, open driver’s
door and pull turn signal stalk towards
steering wheel. Close driver’s door.
The dipped beam remains switched on
for approx. 30 seconds after closing the
driver’s door.
Instrument illumination k,
information display illumination:
Brightness can be adjusted when the
exterior lights are on:
Hold down adjustment button until
desired brightness is obtained.
Operating turn signal lights:
Right = Stalk upwards
Left = Stalk downwards
Turn signal stalk returns to its original
position after use. When steering wheel
is re-centred, turn signal lights are
automatically cancelled.
Activating main or dipped beam:
Main beam = Push stalk forwards
Dipped beam = Push stalk forwards
again or pull towards
steering wheel
Pull stalk towards steering wheel to
operate headlight flash.
Windscreen wiper:
Gently tap stalk upwards
§= Off
$= Adjustable timed interval wipe
%= Slow
&= Fast
Windscreen wash system:
Pull stalk towards steering wheel.
The wiper swipes for a few strokes.
On vehicles fitted with a rain sensor 3,
keep the sensor area clean by operating
the system regularly.
Hazard warning lights:
On = Press ¨
Off = Press ¨ again
Pushbutton surface is illuminated when
the ignition is switched on.
Heated rear window,
heated exterior mirrors 3:
Operational only with engine running.
Heating is switched off automatically
after approx. 15 minutes.
Clearing misted or icy windows:
Set air distribution to l, turn rotary
knobs for temperature and fan
clockwise. Open air vents and direct
side air vents towards door windows.
Child restraint systems 3:
Child restraint systems may only be
fitted on the front passenger’s seat if the
front and side airbags 3are
deactivated for the front passenger’s
seat.
The use of child restraint systems with
active front and side passenger airbags,
pose a risk of fatal injury.
Front passenger’s airbag system
deactivation:
Switch ignition on, control indicator *
flashes, and LEDs in button display
current status. Press and hold button *
within 15 seconds. After approx. 2
seconds, you will hear a confirmation
buzzer. Release button * after another
4 seconds at the latest.
LEDs in the button not illuminated:
Airbag systems for the front
passenger’s seat are active.
LEDs in the button illuminated:
Airbag systems for the front
passenger’s seat are not active.
For more information, see Owner’s
Manual.
Steering wheel adjustment 3:
Move lever down, adjust height and
distance, move lever up and engage.
Adjust steering wheel only when vehicle
is stationary and steering column lock is
released.
Fitting seat belt:
Adjust height such that the belt passes
over the wearer's shoulder and rests
against the shoulder. It must not pass
over the neck or upper arm.
Pull belt slightly, press button on
adjuster and slide to correct height.
Allow anchorage to lock audibly.
Do not adjust height while driving.