Manual installation Veko Sensor
Manual Veko linear lighting system / V20 / 2021-02
1
4
7
9
2
5
8
3
6
MD-L-R
- Length -
- Width -
MD-L-N
This page applies to all MD-L subtypes and config-
urations.
1 Switch off the power supply before connecting the
light system.
2 Example of a sensor. Note: Sensor type
and/or linear lighting profile may vary.
3 Ensure correct position of poles and wiring.
Plug the connector into the flat cable.
5 Press and attach the safety clip for
emergencies in the continuous-row
lighting profile.
6 Install the sensor in the profile.
7 In the case of the Narrow lens, a cover
can be used to limit the range of the
sensor, if necessary. This cover can be cut to size
with pliers or scissors on the break line to achieve
the desired range and angle of the sensor.
8 Technical data.
9 Sensor range:
MD-L-R (round lens)
MD-L-N (narrow lens)
Technical data
Power (W)
Voltage (V)
Length (mm)
Frequency (Hz)
Circuit
Sensitivity settings
Twilight circuit
Switch-off delay relay
Environment application
Corridor function / dynamic switch
(example: 10-100 %)
Programming
ENEC certification
Warranty
1,5 W < 4 W (Switched off- < on)
220-240 V
300 mm
50 ÷ 60 Hz
6 A
5 (standard max. sensitivity)
Adjustable in 9 steps 0-1.000 Lux
Relay 0-99 minutes
-25 °C - + 35 °C
In combination with DALI driver
and control gear
Readout and re-programmable by
colour coding with LED in sensor
In application at DEKRA
5 years
