Your kit includes:
ESL18, ESL24, ESL36, ESL48:
Parts
Top structure x1
Legs x4
Shelf x1
Fasteners
1/4" x 1/2" bolt x8
3/8” x 1 1/4" bolt x16
1/2" x 1" bolt x4
3/8" x 23mm washer x16
EST18, EST24, EST36, EST48:
Parts
Top structure x1
Legs x4
Shelf x1
Table top x1
Fasteners
1/4" x 1/2" bolt x8
3/8” x 1 1/4" bolt x16
3/8" x 23mm washer x16
ESL60, ESL72:
Parts
Top structure x1
Legs x6
Shelf x1
Fasteners
1/4" x 1/2" bolt x12
3/8” x 1 1/4" bolt x24
1/2" x 1" bolt x4
3/8" x 23mm washer x24
EST60, EST72:
Parts
Top structure x1
Legs x6
Shelf x1
Table top x1
Fasteners
1/4" x 1/2" bolt x12
3/8” x 1 1/4" bolt x24
3/8" x 23mm washer x24
1
Place Top Structure upside
down on clean flat surface.
2
Place Leg bracket and line up holes.
Use 3/8" x 1 1/4" bolts and washers
to secure legs in place. Use a 14mm
wrench to tighten bolts.
3
Fit legs through shelf holes and
adjust to desired height.
4
Fix shelf in position by fastening 1/4" x
1/2" bolts using a 7/16" wrench.
Tighten all legs in a criss-cross pattern.
5
Turn stand upright and place your
Venancio appliance on top. Use 1/2"
x 1" bolts to secure it in place. Rotate
leg end nuts to level the stand so it is
sturdy and doesn’t shake during use.
For ESL models only 5
Turn stand upright and install the table
top. Rotate leg end nuts to level the
stand so it is sturdy and doesn’t shake
during use.
For EST models only
Parts layout
Top structure
(ESL models)
Top structure
(EST models)
Leg Shelf Table top
(EST models)
Assembly requires two people.
