7
4. My device can't be connected to network with App
• Make sure the device is under the config status (indicator light is flashing
quickly).
• Make sure the Wi-Fi is avaliable and the device is not far away from the
router.
• Make sure the Wi-Fi password you input is correct.
• Make sure the Wi-Fi security protocol is not WPA3.
5. My device shows oine in my App
• Make sure the device is powered on.
• Make sure the network is stable and the Wi-Fi name and password not
modifed. If not, add device again.
• If the network is normal, but its still one. Check if there are too many Wi-Fi
connections. You can resta your router to check the status of the device.
Caution:
This device complies with Pa 15 of the FCC rules and Indust Canada license‐
exempt RSS standard(s). Operation is subject to the following two conditions: (1)
this device may not cause harmful inteerence, and (2) this device must accept any
inteerence received, including inteerence that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modications or change to this equipment. Such modications or
change could void the user’s authority to operate the equipment.
This radio transmitter (identify the de vice by certification number or model
number if Catego II) has been approved by Indust Canada to operate with the
antenna types listed below with the maximum permissible gain indicated. Antenna
types not included in this list, having a gain greater than the maximum gain
indicated for that type, are strictly prohibited for use with this device.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to pa 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful inteerence to radio communications. However, there is no guarantee that
inteerence will not occur in a paicular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to t to correct the
inteerence by one or more of the following measures:
‐‐ Reorient or relocate the receiving antenna.
‐‐ Increase the separation between the equipment and receiver.
‐‐ Connect the equipment into an outlet on a circuit dierent from that to which
the receiver is connected.
‐‐ Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
To maintain compliance with FCC’s RF exposure guidelines, this equipment should
be installed and operated with a minimum distance of 20cm between the radiator
