Vibe S75T02 Series User manual
Vibe S1 75
User Manual
( Please ead this manual befo e ope ation. )
Read and follow these instructions when connecting and using your display:
Operation:
Keep the display out of direct sunlight and open ames, hot appliances, or any other heat sources
Remove any object that could fall into ventilation holes or prevent proper cooling of the display’s
electronics
Do not block the ventilation holes on the Vibe
When positioning the display, make sure the power plug and outlet are easily accessible
When turning off the display by detaching the power cord, wait 6 seconds before re-attaching the
power cord for normal operation
Ensure the use of an approved power cord at all times. If your power cord is missing, please contact
your local service center
Do not subject the display to strong vibration or high impact during operation
Avoid dropping the display during operation or transportation
his apparatus is intended to be supported by a UL Listed Wall Mount Bracket or equivalent.
emperature: 0-40°C 32-104°
Humidity: 20-80% R
Altitude: 5000
he forward tilt of the product will affect the touch effect. he suggested
installation angle is 0°-5°.
WARNING: Use of controls, adjustments or procedures other than those specied in this
documentation may result in exposure to shock, electrical hazards and/or mechanical
hazards.
Safety Instructions
Safety precautions and maintenance
ii
Maintenance:
o protect your display from possible damage, do not put excessive pressure on the LCD panel. When
moving your display, hold the frame to lift; do not lift the display by placing your hand or ngers on
the LCD panel
Unplug the display if you are not going to use it for an extensive period of time
Unplug the display if you need to clean it with a slightly damp cloth. he screen may be wiped with a
dry cloth when the power is off. Never use organic solvent, such as alcohol, or ammonia-based
liquids, to clean your display
o avoid the risk of shock or permanent damage to the hardware, do not expose the display to dust,
rain, water, or a moist environment
If your display becomes wet, wipe it with a dry cloth as soon as possible
If a foreign substance or water gets in your display, turn the power off immediately and disconnect
the power cord. hen remove the foreign substance or water and send the unit to the maintenance
center
Do not store or use the display in locations exposed to heat, direct sunlight or extreme cold
In order to maintain the best performance of your display and ensure a longer lifetime, we strongly
recommend using the display in a location within the following temperature and humidity ranges:
IMPORT NT: Always activate a moving screen saver program when you leave your display unattended.
Always activate a periodic screen refresh application if the unit will display unchanging static content.
Uninterrupted display of still or static images over an extended period may cause “burn in”, also known
as “after-imaging” or “ghost imaging”, on your screen. This is a well-known phenomenon in LCD panel
technology. In most cases, the image will disappear gradually after the power has been switched off.
WARNING: Severe “burn-in” symptoms will not disappear and cannot be repaired. This is not covered
under the terms of your warranty.
Service:
The casing cover should only be opened by qualied service personnel
If there is any need for repair or integration, please contact your local service center.
Important Safety Instructions
Read these instructions
Keep these instructions
Heed all warnings
Follow all instructions
Do not use this apparatus near water
Clean only with dry cloth
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including ampliers) that produce heat
Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades, one wider than the other. A grounding type plug has two blades and a third grounding prong.
The wide blade or the third prong are provided for your safety. If the provided plug does not t into
your outlet, consult an electrician for replacement of the obsolete outlet
Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus
Only use attachments/accessories specied by the manufacturer
Use only with the cart, stand, tripod, bracket, or table specied by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid
injury from tip-over. Use with other (carts, stands, or carriers) may result in instability causing injury
Unplug this apparatus during lightning storms or when unused for long periods
Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been
damaged in any way, such as if the power-supply cord or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
If your display does not operate normally, having followed the instructions in this
document, please contact a technician or your local service center.
iii
ESD Warnings
Warning:
When ser close to the monitor, it may ca se the eq ipment discharge and reboot to the display of main
men .
This eq ipment is compliant with Class A of EN55032/CISPR 32. Operation of this eq ipment in a
residential environment co ld ca se radio interference.
Use only an RF shielded cable that was s pplied with the display when connecting this display to a
comp ter device
To prevent damage which may res lt in re or shock hazard, do not expose this appliance to rain or
excessive moist re.
Yo r new P blic Information Display contains materials that can be recycled and re sed. Specialized
companies can recycle yo r prod ct to increase the amo nt of re sable materials and to minimize the
amo nt to be disposed of
Please nd o t abo t the local reg lations on how to dispose of yo r old display from yo r local dealer
(For customers in Canada and U.S.A.
This prod ct may contain lead and/or merc ry. Dispose of in accordance to local-state and federal
reg lations. For additional information on recycling, contact www.eia.org (Cons mer Ed cation Initiative)
Attention users in United States
Please dispose of the prod ct according to all Local, State and Federal Laws. For disposal or recycling
information, contact: www.mygreenelectronics.com or www.eiae.org.
Federal Communications Commission (FCC) Notice (U.S. Only)
End-of-Life Disposal
Waste Electrical and Electronic E
q
uipment--WEEE
This eq ipment has been tested and fo nd to comply with the limits for a Class A digital
device, p rs ant to part
1
5 of the FCC R les. These limits are designed to provide
reasonable protection against harmf l interference when the eq ipment is operated in a
commercial environment. This eq ipment generates, ses and can radiate radio freq ency
energy and, if not installed and sed in accordance with the instr ction man al, may
ca se harmf l interference to radio comm nications. Operation of this eq ipment in a
residential area is likely to ca se harmf l interference in which case the ser will be
req ired to correct the interference at his own expense.
This device complies with Part
1
5 of the FCC R les. Operation is s b
j
ect to the following
two conditions: (
1
) This device may not ca se harmf l interference, and (2) this device
m st accept any interference received, incl ding interference that may ca se ndesired
operation.
Changes or modications not expressly approved by the party responsible for compliance
co ld void the ser
’
s a thority to operate the eq ipment.
iv
End of Life Directives--Recycling
Your new ublic Information Display contains several materials that can be recycled for
new users
lease dispose of according to all Local, State, and Federal laws.
Disposal of Waste Equipment by Users in rivate Househould in the European Union
This symbol on the product or on its packaging indicates that this product must not
be disposed of with your other household waste. Instead it is your responsibility to
dispose of your waste equipment by handing it over to a designated collection point
for the recycling of waste electrical and electronic equipment. The separate
collection and recycling of your waste equipment at the time of disposal will help to
conserve natural resources and ensure that it is recycled in a manner that protects
human health and the environment. For more information about where you can drop
off your waste equipment for recycling, please contact your local city ofce, your
household waste disposal service or the shop where your purchased the product.
The product may fall, causing serious personal injury or death. To prevent injury, this product must be
securely attached to the oor/wall in accordance with the installation instructions. Many injuries,
particularly to children, can be avoided by taking simple precautions such as
ALWAYS use cabinets, stands, or installation methods recommended by the manufacturer of the product.
ALWAYS use furniture that can safely support the product
ALWAYS ensure the product is not overhanging the edge of the supporting furniture
ALWAYS educate children about the dangers of climbing on furniture to reach the product or its controls
ALWAYS route cords and cables connected to your product so they cannot be tripped over, pulled or
grabbed
NEVER place a product in an unstable location
NEVER place the product on tall furniture (for example, cupboards or bookcases) without anchoring both
the furniture and the product to a suitable support
NEVER place the product on cloth or other materials that may be located between the product and
supporting furniture
NEVER place items that might tempt children to climb, such as toys and remote controls, on the top of
the product or furniture on which the product is placed
If the existing product is going to be retained and relocated, the same considerations as above should be
applied.
This radio transmitter has been approved by Industry Canada
This Class B digital apparatus complies with Canadian standard CAN ICES-003(B)/NMB-003(B). This device
complies with Industry Canada License exempt RSS standard(s). Operation is subject to the followin
two conditions. This device may not cause interference and (2) this device must accept any interference,
including interference that may cause undesired operation of the device
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20cm between the radiator
& your body.
Stability Hazard
v
This manual suits for next models
3
