VIBESTA PERAGOS Disk 30C User manual

VIBESTA B.V. Steenovenweg 5, 5708HN Helmond, The Netherlands
User Manual V1.0
June 2019
User Manual
Disk

2
MAIN MENU
RGBWW Multi-color
30C
Interface -----------------
CCT Mode ----------------
HSI Mode -----------------
Gel Mode -----------------
Channel & Frequency ----
SW Version ---------------
Presets -------------------
Error Codes --------------
3
4
4
5
6
6
7
7
>
>
>
>
>
>
>
>
Daylight / Bi-color
304P / 304B
Interface -----------------
White Light Mode----------
Channel & Frequency ----
SW Version ---------------
Presets -------------------
Error Codes --------------
8
9
10
10
11
11
>
>
>
>
>
>

330C RGBWW Multi-color
CCT Mode > HSI Mode > Gel Mode
Mode Cycle Switch
DMX Channel > Software Version
Setting Cycle Switch
> Interface

430C RGBWW Multi-color
To toggle between Intensity & Color Temperature
(Press to go into CCT Mode)
To set Intensity (%) or Color Temperature (K)
> CCT Mode
(Press to go into HSI Mode)
> HSI Mode
Knob Press
Knob
To toggle between Intensity &Hue &Saturation
To set Intensity (%) or Hue (H) or Saturation (Sat)
Knob Press
Knob

5
30C RGBWW Multi-color
To toggle between Gel & Intensity & Color Temperature
To set Gel No. (GEL) or Intensity (%) or Color Temperature (K)
> Gel Mode
Knob Press
Knob
(Press to go into Gel Mode)

(Press to go into Channel & Frequency Select)
> Channel & Frequency
(Press to go into Software Version Interface)
6
30C RGBWW Multi-color
> SW Version
To exit the Software Version InterfacePress
To toggle between Channel (CH) & Frequency (PRE)
To set Channel (CH) or Frequency (PRE)
Knob Press
Knob
To save and exitPress

> Presets
To Save the light parameters in a preset+ /
/To Recall a saved preset
7
30C RGBWW Multi-color
Low voltage
> Error Codes
High voltage Temperature is too high

8
304P / 304B Daylight / Bi-color
Flash Test
> Interface
Save and Exit
>>>>>>>>>>>>>>>>Press
for 3 seconds >>>>
Press to go into Setting

9
304P / 304B Daylight / Bi-color
To toggle between Intensity & Color Temperature*
To set Intensity (%) or Color Temperature (K)*
> White Light Mode
Knob Press
Knob
To test FlashPress
In White Light Mode the flash function can be triggered by
a connected SYNC cable.
* Color Temperatur only for Bi-color models

10304P / 304B Daylight / Bi-color
(Press for 3 seconds to go into Channel & Frequency Selection)
> Channel & Frequency
(From Channel & Frequency Selection, press to go into Software Version Interface)
> SW Version
Exit to the White Light ModePress
To toggle between Channel (CH) & Frequency (PRE)
To set Channel (CH) or Frequency (PRE)
Knob Press
Knob
To save and to go into Software Version InterfacePress
Exit to the White Light ModePress

11
304P / 304B Daylight / Bi-color
> Presets
To Save the light parameters in a preset+ /
/To Recall a saved preset
Low voltage
> Error Codes
High voltage