Vicoustic VicBooth User manual

1
Installation Manual
Ventilation
Unit

2
Included
Ventilation unit | 1 uni.
Not included
Screwdriver
Material Needed
Fixing screws | 6 uni.
P
Insulation Seal | 1 uni.
USB extension cable (3m) | 1 uni.
Remote control electrical outlet | 1 uni.USB power adapter | 1 uni.
USB extension cable (0.3m) | 1 uni.

3
1Start by placing the Insulation seal on the ceiling of the VicBooth.
2Place the Ventilation unit aligned with the Insulation seal and the xing holes.

4
3Fix the Ventilation unit using the included screws (P) and a 6mm Phillips Screwdriver.
Step’sMaterial
P
Screwdriver

5
Step’sMaterial
1
2
3
Step’sMaterial
4Connect the included USB extension.
5Connect the Remote Control Electrical Outlet and the USB power adapter to a wall socket.
You can switch the fan ON and OFF from inside the cabin using the remote control.

6
!The switches should always be set to high.

7
6Up to two ventilators can share the same USB power source and must have their inline speed controller set to
high to prevent overload.
In case the ventilators are going to be installed too far away from each other, you can use the 0.30m USB
extension to connect them to each other.

8
© Vicoustic, 2021 | V3
No parts of this document might be copied and/or
published without written consent of Vicoustic.
Main Oce, R&D & Logistics
Avenida do Pólo 3, Nº 159, Carvalhosa
4590-137 Paços de Ferreira, Portugal
Oce
Rua Quinta do Bom Retiro Nº 16, Armazém 9
2820-690 Charneca da Caparica, Portugal
T ([phone]
Info and Sales
E [e-mail]
www.vicoustic.com