Videotree LIFESTYLE Series Instructions for use

www.videotree.com
Tel: [phone]
1
LUXURY WATERPROOF TELEVISIONS MADE IN ENGLAND
LIFESTYLE RANGE
ON-WALL RANGE: 27” / 32” / 42” / 46” / 55”
QUICK INSTALL &
SETUP GUIDE
Quick installation guide for Videotree’s on-wall range of
waterproof televisions.
This guide is provided as an overview of the installation
procedure. Please refer to your user manual for full
installation instructions.
2 YEAR
Warranty
IP66
Protection Rating

www.videotree.com
Tel: [phone]
2www.videotree.com
Tel: [phone]
3
TELEVISION DIMENSIONS INSTALLATION
Use the dimensions below and diagrams opposite to understand the size of your television and backbox.
WARNING:
If you are unsure about the installation of your television STOP IMMEDIATELY and contact a professional. Incorrect installation
could result in bodily injury or damage to the television.
This guide is provided as a simple overview of the installation process. Please refer to the full User Manual for complete
installation and setup instructions. If you are unsure about the installation of your television STOP IMMEDIATELY and contact a
professional. Incorrect installation could result in bodily injury or damage to the television.
*Measurements are in millimetres (mm) unless otherwise stated.
TELEVISION SIZE
KEY* 27” 32” 42” 46” 55”
A639 747 986 1073 1266
B389 452 589 637 747
C35 43 43 43 43
PACKAGING DIMENSIONS
Length 735 820 1200 1250 1500
Depth 180 100 100 100 200
Height 550 520 650 700 1200
Weight (kg) 16kg 22kg 29kg 35kg 40kg
VESA MOUNT DIMENSIONS
Fixing Holes 100 X 100 200 X 200 400 X 400 400 X 400 400 X 400
WARNING:
When removing your television from the packaging, ensure that you are able to lift the television safely. We recommend that
2 persons are present to lift and move the larger televisions.
When lifting your television, face the screen away from your body and hold the top and the bottom of the frame securely. Do
NOT hold the screen or place excessive pressure on the screen.
NOTE:
Before installing your television, we recommend that you connect the television to a power source and ensure that it is
working correctly.
!
A
B
C
WARNING:
Ensure the cables are long enough to reach your television and any power outlets or external devices.
Ensure the mains supply socket is switched o before connecting your television power supply.
We recommend using at least two persons to lift the television.
The rear of the television is NOT water resistant. Do NOT expose the rear of the television to water. If you do not correctly
seal any gaps between the television and the wall, your television could become exposed to moisture or dust and your
warranty will be voided.
STEP 1
Once you have determined the best position for your on-
wall television, mark out and x the wall mount brackets
to the wall using coach bolts and wall plugs if required.
Ensure that you correctly measure the xtures and
ttings to align with your television, ensuring that they
are positioned as straight and level as possible.
Wall plugs
Coach Bolts
Use measurement tools to ensure level mounting
Spirit Level
Keep cables as close to the wall
mount as possible
STEP 2
Once you have xed your wall mount brackets, install the
wiring required to operate your television - power supply,
HDMI cable, aerial cable etc.
We recommend xing your wiring into the wall and
keeping the cables as tight to the wall as possible.
Silicon seal between the
edges of the screen and
the wall
STEP 3
We recommend that you test your television once the
wires have been xed into the wall (this may require two
persons).
Connect the wires to the television and place the television
onto the brackets. Test that your television is working
correctly and that the cables are correctly inserted into
the back of the television before applying sealant.
Once you have ensured your television is working correctly
and that all the cables have been connected, use a silicon
sealant to seal between the edges of your television and
the wall. Ensure that any gaps are completely sealed
to prevent ingress of water and dust to the rear of the
television. Your television is ready for use!

www.videotree.com
Tel: [phone]
4www.videotree.com
Tel: [phone]
5
AUTO-INSTALLATION AUTO-INSTALLATION CONTINUED
If this is the rst time you are turning on the TV and there are no programs in the TV memory, the “Auto Installation”
menu will appear on the screen. Using the MASTER remote control, follow the 5 setup steps as below:
Setup 1: Set up Home Setup 2: Select the Country
Setup 3: Select the Language Setup 4: Select “Auto-Power O”
Setup 5: Select the TV Connection Setup 6: Select the “Auto-Search” (air/cable type)
OPTION VALUE
Load Default Database /
Database Import
Import default Satellite
database
Satellite System Enter “Satellite System”
menu for settings
Setup 6.1: Set up the Satellite
KEY STROKE ACTION
KEY_UP Focus on the previous item/
program
KEY_DOWN Focus on the next item/program
KEY_MENU Exit Menu
KEY_CHANNEL_LIST Exit Menu
KEY_RED Show “Find” Mode Menu
Setup 7: Channel List Menu Key Stroke In Menu:
Setup 8: Favourite Menu Key Stroke In Menu:
KEY STROKE ACTION
KEY_UP Focus on the previous item/program
KEY_DOWN Focus on the next item/program
KEY_MENU Exit Menu
KEY_FAV_LIST Exit Menu
KEY_RED Show “Rename Favourite List Name” Menu
Options In Menu:

www.videotree.com
Tel: [phone]
6www.videotree.com
Tel: [phone]
7
EXTERNAL SPEAKER CONNECTIONS EXTERNAL SPEAKER CONNECTIONS CONTINUED
The ‘Speaker Out’ port can be found
on the left of the control panel on the
rear of the television.
Two external speakers (left and right)
can be connected to this port using
standard red and black speaker
cables (not provided).
Cable Connections:
Red = Positive +ve
Black /Red & Black = Negative -ve
-
+
-
+
L
R
SPEAKER
STEP 2
CONNECT SOCKET TO THE TV
Plug the green socket (with wires
now attached) back into the main
control panel. This should simply
‘snap’ back into place.
X
STEP 3
CONNECTION TO SPEAKER
Connect the speaker cables
to the external speakers by
connecting them to the socket.
The image shown is the
connection to Videotree’s
External Ceiling Speakers. Lift or
press the plastic levers to open
or close the sockets to insert
the cable connections from the
television.
NOTE:
External speakers and speaker
cables are NOT supplied with
your television.
-
+
-
+
L
R
SPEAKER
STEP 1
CONNECT TO THE TV SOCKET
Unplug the green speaker socket
from the main control panel.
Unscrew the required connection
sockets on the back of the television
and place the cable connections into
the correct sockets as shown in the
image.
Do NOT use the central socket.
Screw the screws back into position
so that they rmly hold the cable
connections. Do not place excessive
force onto the screws.
X
SPEAKER

www.videotree.com
Tel: [phone]
8www.videotree.com
Tel: [phone]
9
MASTER REMOTE CONTROL LEARNING REMOTE CONTROL
Volume Up (+)
Volume Down (-)
Record
Text (Rewind)
Power
On/O
Picture Mode
Mute
Main
Menu
Electronic Guide
EPG
(Skip backwards)
Index (Play/Pause)
Hold (Fast Forward)
Channel/Programme
Information
Sleep Mode
Channel Up (+)
Channel Down (-)
Source Select
Subtitle Toggle
(Skip Forward)
TV Source
Select
Subpage (Stop)
Exit
Favourite
Aspect
Sound Mode
Audio
Timeshift
Number
Selection
The Playback
Functions (Play/
Pause/Stop etc.) will
operate in certain
source modes.
Edge
Illumination
Control
Channel Up
Channel Down
TV Source
Select
Volume Up
Volume Down
Record
Sleep Mode
Pause
Rewind
Source
Select
TV Guide
Power On /
Power O Mute
Main Menu
Exit
Play
Fast Forward
Channel/Programme
Information
(Subtitle Toggle)
Teletext
Stop
Number Selection
PLEASE NOTE: The Master Remote Control is NOT waterproof.
Do NOT get wet or submerge under water.
PLEASE NOTE: The Learning Remote Control is NOT waterproof.
Do NOT get wet or submerge under water.

Power ON/OFF & Standby Function:
Press the RED “POWER” button to turn the TV ON & OFF. When your TV is ON press the “POWER” button to
enter standby mode. When your TV is in Standby Mode, press the ‘’POWER’’ button to start it.
Channel Switching:
In the TV or DTV (Air) Source, you can switch the channel by pressing either “CH ” or “CH ” button.
Volume Adjust:
Adjust the volume by pressing either
“VOL ” or “VOL ” buttons. A volume adjusting level will appear on the screen displaying the current
volume.
Mute Function:
To mute the sound, simply press the “MUTE” button. To unmute the sound, press the “MUTE” button once
more.
To Access the Electronic Programme Guide (EPG):
Press the “GUIDE” button and the EPG will appear on the screen. Use the “ “ and “ “ buttons to navigate
through the channels and the “ “ and “ “ buttons the view the dierent programmes for each channel.
Press the central “OK” button to select a current programme or to set a reminder for a future programme.
To exit the EPG, simply press the “GUIDE” button once more.
Sleep Function:
When your TV is ON, press the “SLEEP” button to start the “Sleep” function which will automatically turn
the TV OFF after a certain period of time. Continue to press the “SLEEP” button to select a certain time
period or turn the function OFF.
Switching the Input Source:
After the normal start-up process, press the “Source” button, then either “Up” or “Down” button to choose
the preferred source, then press either the “OK” or “ ” button to nish.
Info Function:
To nd the current Source press the “Info” button to view the Source and additional information such as:
Channel Number / Colour System / Sound System (in the TV source) / Current Frequency / Bandwidth /
Event Information / etc. (in the DTV (Air) Source).
Set up Picture Mode: Select MENU then choose Picture
Pressing the “PMODE” button will change the parameters of the displayed picture such as:
Luminance / Contrast / Sharpness / Hue / Colour etc.
This function can also be found in the Main Menu.
Set up Sound Mode: Select MENU then choose Sound
Pressing the “SMODE” button will change the parameters of the sound such as:
Balance / Maximum Volume / Minimum Volume etc.
This function can also be found in the Main Menu
www.videotree.com
Tel: [phone]
10
COMMON SHORTCUTS
Unit 1 Ember Centre
Hersham Trading Estate
Lyon Road
Walton-On-Thames
Surrey, KT12 3PU
United Kingdom
Tel: [phone] (Mon-Fri, 9am-5pm)
Overseas: [phone]
Fax: [phone]
Email: [email protected]
Web: www.videotree.com
If you have any questions regarding the installation or set-up of
your on-wall television, please contact Videotree via the details
opposite.
The contents of this guide are subject to changes at anytime.
Please refer to your instruction manual or contact Videotree for more information.