OneTrack - © 2019 Video
Wave
2
Steps to Configure the OneTrack
Power the OneTrack system and connect it to the network
Make sure the Internet connection is present on the system
Connect all cameras (ie: fixed and PTZ) to the same network
Configure all cameras to static IP addresses in the same network segment
Power and connect the ADAM-60XX IP Alarm Module to the same network
Also configure the ADAM-60XX alarm module to a static IP address. Please
refer to the module installation guide.
In the event that the manufacturer is configuring the OneTrack system,
please give Teamviewer access by providing the ID and password. If the
Teamviewer software is not present, please download and install it.
https://www.teamviewer.com
If you need to fully configure the system, please refer to the installer's
guide and the user guide.
After the OneTrack system is configured and functional, install and
configure remote access on each client node.
Make sure that the default ports on the OneTrack system are redirected to
the router for remote access from outside.
For further questions, please refer to the troubleshooting guide or contact
the manufacturer for technical support on the product concerned.
