Vinotemp CELLAR TRELLIS WINE RACK User manual

ASSEMBLY INSTRUCTIONS
CELLAR TRELLIS WINE RACK
732 S. Racetrack Road | Henderson | Nevada 89015
1.800.777.8466 | Fax: [phone] | www.vinotemp.com
Step 1: Lay out vertical strips with notches.
Step 2: Insert horizontal strips into vertical strips.
Step 3: Insert dowels at one end of the rack to hold
rack steady.
Step 4: Insert dowels at the other end of the rack
and insert rest of horizontal strips by bisecting the
rack. Insert dowels through center of rack (this
keeps strips from coming out of the notches.)
Install remaining dowels, working from center of
the rack towards the outside.

Step 5: Place vertical strips on dowels.
Step 6: Place horizontal strips over vertical strips.
Step 7: Place nails in all four corners; tap lightly
with hammer. (Do not drive nails around perimeter of
rack.) This holds strips in place and holes aligned.
Starting at the center of rack, place remainder of
nails in holes; tap lightly with hammer. After all nails
are in place, start at center of rack and drive in the
nails completely. (The reason for starting at the
center is that it is easier to remove and replace.)
Note: To assemble rack, work on a level, solid surface such as
3/4” pressed board. There may be extra pieces (dowels and
nails) left after rack has been assembled.
ASSEMBLY INSTRUCTIONS
CELLAR TRELLIS WINE RACK
732 S. Racetrack Road | Henderson | Nevada 89015
1.800.777.8466 | Fax: [phone] | www.vinotemp.com