Vivo DESK-V221 User manual

Child’ Heigh Adjuable
Dek
Instruction Manual
Email: [email protected]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
- Model DES V22
Scan the QR code with your mobile device or follow the link
to helpful videos and specifications related to this product.
Aembl Sep
Tool equired
phillips screwdriver
Package Conen
1
Sep 
B2 (x2)
Fron Righ/Rear
Lef Leg
B4 (x2)
Suppor Bar
B (x1)
Deskop
B3 (x2)
Fron Lef/Rear
Righ Leg
A (x8)
M6x12
A2 (x12)
M6x16
A3 (x4)
Bumpers
A4 (x1)
llen Wrench
- -hp//vivo u.com/produc/dek v22
Mount support bars (B4) to front left/rear right legs (B3)
using M6x12 bolts (A1) and Allen wrench (A4).

If you do not understand these directions, or if you have any
doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no
missing or defective parts. Improper installation may cause
damage or serious injury. Do not use this product for any
purpose that is not explicitly specified in this manual. We
cannot be liable for damage or injury caused by incorrect
assembly or inappropriate use.
Email: [e-mail]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
For more VIVO products, check out our
website at
www.vivo-us.com.
If any parts are received damaged or defective, please contact
us. We are happy to replace parts to ensure you have a fully
functioning product.
Safe Warning
Conac u a
Last updated: 06/08/18 2
Sep 2
Sep 3
Sep 4
Sep 5
Attach corner bumpers (A3) to
corners of desktop.
To Raise the Desk: With one person standing
on each side of the desk, each person must
place one foot on the support bars (B4 ).Gently
lift the desk to the desired height.
To Lower the Desk: Gently lift the desk to the
maximum height, then slowly lower to the
minimum height. The desk may be raised
again after lowering to the minimum height.
Mount front right/rear left
legs (B2) to other ends of
support bars (B4) using
M6x12 bolts (A1) and Allen
wrench (A4).
Mount leg assemblies (B2, B3, B4) to desktop
(B1) using M6x16 bolts (A2) and Allen
wrench (A4).