Vivo STAND-TV08 User manual

  
Instruction Manual
Email: [email protected]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
-  
 
phillips screwdriver
 
1
Scan the QR code with your mobile device or follow the link
to helpful videos and specifications related to this product.
- - !! "#   !
 (x1)
Pol wit Slf
$ (x1)
Bas
 (x1)
VES Plat
 (x2)
Dcorativ Covr
% (x8)
M6x5
 (x2)
Lft r
& (x2)
Rigt r
' (x4)
Rubbr Pad
( (x1)
Brackt Covr
) (x2)
Cabl Clip
* (x4)
M8x14
+ (x1)
Wrnc
 (x1)
4 lln
Wrnc
 (x1)
5 lln
Wrnc
-  (x4)
M5x14
-  $ (x4)
M6x14
-  (x4)
M6x30
-   (x4)
M8x30
- & (x4)
Wasr
-  ' (x4)
Spacr
- % (x4)
M8x50
-   (x4)
Wasr
-  ( (x4)
Spacr

#,- 
2
 .
 /
Carefully flip base
(B) upside down by
holding plastic tie.
Place rubber pads
(H) on corners of
base (B) as shown,
turn base (B) right-
side up, and cut
plastic tie.
Slide decorative cover (D) onto pole (A).
Attach pole (A) to base (B) with M8x14 bolts
(K) using mm allen wrench (N).
 0
 1
2   $ 
Attach arms (F and G) to VESA plate (C) in desired position with M6x
bolts (E).
Attach VESA plates with arms (F and G) to back of TV with screws (M-
A or M-B) and washers (M-F or M-G).

 3 45
 6
Attach cover (I) to top of
pole (A), and cable clips (J)
to back.
 1 45
2 $ ! $ 
 3
Attach VESA
plates with
arms (F and G)
to back of TV
with screws (M-
C, M-D, or M-E),
washers (M-G),
and spacers (M-
H or M-I).
Remove nut from bottom of VESA plate (C), then hang
VESA plate over slot on top of pole (A). Secure with the
previously removed nut and tighten with wrench (L).
3

If you do not understand these directions, or if you have any
doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no
missing or defective parts. Improper installation may cause
damage or serious injury. Do not use this product for any
purpose that is not explicitly specified in this manual. We
cannot be liable for damage or injury caused by incorrect
assembly or inappropriate use.
Email: [e-mail]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
For more VIVO products, check out our
website at
www.vivo-us.com.
If any parts are received damaged or defective, please contact
us. We are happy to replace parts to ensure you have a fully
functioning product.
7- 8
  
Last updated: 06/14/18
 9
:  
Loosen the knobs as shown in the diagram to collapse the tray or
adjust tray height.
4