VMP W-20B User manual

For more information, please contact us at:
325 Log Canoe Circle, Stevensville, Maryland 21666
(T) 410.643.6390 / (F) 410.643.6615
www.videomount.com
VIDEO MOUNT PRODUCTS
Instruction Sheet For:
W-20B, W-20W & W-20S

Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before at-
tempting to assemble the mount.
Step 2
Mark wall or desired mounting surface in preparation of installation
of the wall plate to desired surface. Pre-drill, if necessary, and
mount wall plate to desired surface. Make sure the wall plate
is secure on the mounting surface. Note: Make sure the smaller
hole on the wall plate’s flanges is mounted upwards and the larger
hole downwards as shown in picture. Warning: Please verify that your
mounting surface will support the combined weight of your mount,
mounting hardware, and monitor. Also verify that the mounting sur-
face is safe to drill through. If in doubt, contact a professional installer.
Step 3
Insert the support tube into the wall plate from the bottom
up. Insert the plastic washer between the between the top of
the support tube and the wall plate flange . Use a washer
and nylon nut to secure the support tube to the top of
the wall plate .
Step 4
Attach the force arm to the support tube using the M8 screws
. Attach the plastic connectors to the force arm ends )
using the M5 screws .
Step 5
Attach the platform to the plastic connectors by inserting the
5/16” screw through the bottom of the force arm at both ends.
Then place the platform on the screws, making sure the screws come
through the slots cut into the circular depressions in the platform. Se-
cure the platform using washer and nylon nuts .
Step 6
Snap the plastic swivel onto the plastic connector and plas-
tic cover onto the wall plate . Next place your TV onto the
platform and use the safety strap by inserting the end without
the grip through the slot on either side of the platform going over
your TV through the other slot in the platform and wrapping under
the platform and cinching the strap tight.
Step 2: Attaching the wall plate to the
wall (Lag screws are not included)
Step 3: Attaching the support tube
Step 5 : Attaching the platform to
the plastic connectors
WARNING: The installer of these products must verify that the mount-
ing surface, ceiling or wall, will safely support the combined weight
of all attached equipment and hardware. Video Mount roducts will
not be held liable for the improper use or installation of its products.
Enjoy Your Mount!
2
6
3
3
13
87
3
2
14
1
16
Step 4: Attaching the force arm
3
23
3
65
2
1
412
3
15
5
10
6
9 5