CTA PAD-HGTSB User manual

Heavy-Duty Security
Gooseneck Clamp Stand
PAD-HGTSB
INSTRUCTION - MANUAL
CONTENTS:
INSTALLATION:
888-733-4448
1A. Align VESA Gooseneck (A) with screw on clamp (B) and turn it in
clock-wise as shown. **Use Top screw for horizontal surfaces and side screw for
vertical surfaces.
1. Setting Up Clamp to VESA Gooseneck : 2. Attaching Enclosure to VESA
2A. Align holder VESA holes (C) to VESA plate holes (A). Insert washers
and screws (E, D) and turn it in clock-wise into threaded holes in holder
using provide tool (F) until securely tightened. Shown above.
M4 x 8
M5 Allen Key
x4
x1 x1
A
B
D
FG
x1
C
Washer
x4
E
x1
B
x1
A
A
CED
F
X4
X4

888-733-4448
3A. While holder is unlocked, extend tablet holder arms, and insert tablet device into holder. Then, adjust holder arms to fit your tablet device. Shown above.
4A. Insert key (G) into holder key slot (C) and rotate, then remove the key to keep it locked in place. Shown above.
5A. Hold and turn holder
into portrait or landscape
mode as needed.
5B. Move holder gooseneck freely
to desired positon. Shown above.
3. Inserting Tablet into Holder :
4. Locking & Unlocking Holder :
5. Adjusting Angles and Orientation :
**Tablet shown for
illustration and
NOT INCLUDED.
**Tablet shown for
illustration and
NOT INCLUDED.
**Tablet shown for
illustration and
NOT INCLUDED.
G
C
6A.Remove triangle component
when using on tubes or pipes
shaped mounting.
6B.Place triangle component in
place when using on flat surfaces
as tables or countertops. Shown
above.
6. Clamp Modes :