Vuly Nest Swing Large User manual

ASSEMBLY MANUAL
Nest Swing – Large
PRE-INSTALLATION You must attach your Nest Swing - Large only in the configurations shown below - to a
Medium or Large swing set configuration with capacity for two or three standard swings
side by side.
You must not attach onto a Small swing set (with capacity for only one standard swing).
WARNING!
Insert each Tube into the foam that’s inside the four
separate sections around the rim of the Base Material.
Hold the foam as you do so, to ensure that it doesn’t slide
out of the base material.
Ensure that male and female ends of adjacent Tubes are
next to each other and that you have not pushed the foam
out of the Base Material.
2
STEP
1
STEP
Remove a Locking Bolt from both Rail Brackets and slip
them over the Swing Rail where you want to attach your
Nest Swing.
Reinsert the Locking Bolts and tighten the bolts firmly
– until you notice the rubber beginning to squeeze – to
secure the Rail Bracket.
A.
B.
Ensure that they are 1.2 m apart.

ASSEMBLY MANUAL
Nest Swing – Large
You have attached the Nest Swing - Large to your Swing Set.
CONGRATULATIONS!
Thread the bolt with the ropes to hang the swing through
the holes on the completed ring, and fasten.
4
STEP
Connect the Tubes to each other to complete the ring.
Sit the Base Material and Tubes flat on the ground, and
align the holes in the connected tubes.
A.
B.
3
STEP
VULY MINI:
VULY MAX:
Ensure that both carabiners are facing the same
direction and have been firmly tightened.
Remove the first set of carabiners and the Height
Adjustment Straps on both sides of the Swing.
Unlock the carabiners on your Swing, and hook them into
the lugs on the Rail Brackets.
Ensure that both carabiners are facing the same direction
and have been firmly tightened.
Unlock the carabiners on your Swing, and hook them
into the lugs on the Rail Brackets.
A.
B.
5
STEP