Wagan 7316 User manual
Item No. 7316
We are constantly improving our products so specifications are subject to change
without notice. Visit our website for the latest product information.
AC/DC DIGITAL
TIRE INFLATOR
User’s Manual
AC/DC Digital Tire Inflator by Wagan Tech®
1www.wagan.com
Thank you for purchasing the AC/DC Digital Tire Inflator by Wagan Tech®.
With normal care and proper treatment, it will provide years of reliable service.
Please read all operating instructions carefully before use.
CAUTION
• Do not overheat the unit! If the inflator is not pumping a steady stream
of air and appears sluggish or if metal fittings get too warm to the touch,
these are indicators that the inflator has been in operation for too
long. Immediately turn off the inflator and allow it to cool for
approximately 30 minutes before resuming operation. Never leave
inflator unattended while in use.
• Do not over inflate items beyond their needs. Most car tires will inflate
properly between 30 and 35 psi depending upon the tire. Some racing
bicycle tires require pressure in excess of 75 psi. Other bicycle tires
may require substantially lower pressures. This unit is not fitted for high-
pressure tires such as those used on large commercial trucks.
• Keep out of reach of children.
• Plug into a 12V DC socket or a 120V AC socket, but NEVER both at the
same time.
©2023 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
User’s Manual—Read before using this equipment
2
Power Switch
120V AC Plug
Air Hose Nozzle
12V DC Plug
FEATURES
• Automatic shutoff
• Easy-locking air nozzle
• Storage for power cord and air hose
• Adapter tips for balls and inflatables
PSI
BAR
PSI
kPa
AC/DC Digital Tire Inflator by Wagan Tech®
3www.wagan.com
OPERATION
1. Make sure the power switch is in the "Off" position before plugging in.
2. To achieve optimal performance, when powered by the 12V socket, your
vehicle’s engine should be running while operating your tire inflator.
3. Unwind power cord from the storage compartment of the unit and insert the
DC plug into the 12V socket of your vehicle or use the AC cord into a
wall socket.
• Turn the AC/DC switch to the when using the AC plug or to the
when using the DC plug.
4. Pull air hose from compartment.
5. For vehicle tires: Unlock thumb latch of air nozzle by moving to vertical
position (see diagram below) and place air nozzle over valve stem of tire.
6. Push air nozzle down firmly onto valve stem and quickly lock into place by
pressing thumb latch to horizontal position.
7. For other inflatable items: Select the appropriate adaptor and insert it into
the unlocked air nozzle. Lock air nozzle with thumb latch.
Tip: When inflating athletic balls, moisten needle before inserting it into the
ball valve.
Unlocked Position Locked Position
Air Nozzle
Thumb Latch
©2023 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
8. Press the "+" or "−" buttons to set the desired pressure. When the LCD
screen is displaying the target PSI, the LCD readout will blink 3 times at
User’s Manual—Read before using this equipment
4
the desired preset pressure, and it will then change back to the current
pressure of the item that you are inflating.
• Press the air pressure unit button to toggle between BAR, PSI, KPA.
9. Set the power switch to the "|" position to start the inflator. The inflator
will shut off automatically at the desired pressure that you have
programmed. The preset pressure can be changed during inflation by
pressing the pressure adjusting buttons (+/−) to the new desired pressure.
• To stop the tire inflator before it reaches the preset pressure, set the
power switch to the "O" position.
Once the inflator has shut off, set the power switch to the "O"
position.
11.
10.
Disconnect the valve adapter and power cord once the inflation is
complete. Store your tire inflator.
WARNING: DO NOT OVERINFLATE PRODUCTS BEYOND THE
MANUFACTURER’S RECOMMENDATIONS.
WARNING: NEVER LEAVE INFLATOR UNATTENDED WHILE IN USE.
CARE AND MAINTENANCE
• Use only mild soap and a damp sponge to clean compressor.
• Do not immerse any part in liquid.
AC/DC Digital Tire Inflator by Wagan Tech®
SPECIFICATIONS
Maximum Pressure 150 PSI
Air Hose Length 24 in.
DC Cord Length 13 ft
AC Cord Length 6 ft
Power Required 12V 10A DC or 120V AC
Flow Rate 18L/minute
Dimensions 8.1 × 10.5 × 4.6 in.
Weight 3.3 lb
Replaceable Fuse 15A DC
5www.wagan.com
©2023 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
User’s Manual—Read before using this equipment
TROUBLESHOOTING
Problem Solution
Inflator does not
start/blows fuses.
• Push the power plug firmly into the DC socket
and twist it back and forth to ensure clean
contact.
• Check DC socket for dirt and particles. Use a
non-conductive probe to clean the DC socket.
Do not use your fingers or metal.
• Check vehicle lighter fuse; should be 15 amps
minimum.
• Make sure the shutoff pressure setting is not
lower than the current pressure of the item you
are inflating.
Inflator runs but
does not inflate.
• Be sure the nozzle always touches the core of
the valve stem.
• Check tire or other item being inflated for leaks.
• Check hose for breaks and leaks at fittings.
Inflator runs slowly. • Overheated from excessive use. Shut it off and
let it cool for 30 minutes.
• Voltage too low. Check condition of battery.
6
The WAGAN Corporation warranty is limited to products sold only in
the United States.
Warranty Duration:
Product is warranted to the original purchaser for a period of one (1) year from
the original purchase date, to be free of defects in material and workmanship.
WAGAN Corporation disclaims any liability for consequential damages. In no event
will WAGAN Corporation be responsible for any amount of damages beyond the
amount paid for the product at retail.
Warranty Performance:
During the warranty period, a product with a defect will be replaced with a
comparable model when the product is returned to WAGAN Corporation with an
original store receipt. WAGAN Corporation will, at its discretion, replace or repair
the defective part. The replacement product will be warranted for the balance of the
original warranty period. This warranty does not extend to any units which have
been used in violation of written instructions furnished.
Warranty Disclaimers:
This warranty is in lieu of all warranties expressed or implied and no representative
or person is authorized to assume any other liability in connection with the sale of our
products. There shall be no claims for defects or failure of performance or product
failure under any theory of tort, contract or commercial law including,but not limited
to negligence, gross negligence, strict liability, breach of warranty, and breach of
contract.
Returns:
WAGAN Corporation is not responsible for any item(s) returned without an official
Return Authorization number (RA#). Please contact our customer service team by
phone or email to obtain an RA#. You can also visit our website and chat with our team
during our normal business hours. For more details and instructions on how to process
a warranty claim, please read the “Returns” section under the “Contact” page on our
website. WAGAN Corporation is not responsible for any shipping charges incurred in
returning the item(s) back to the company for repair or replacement.
©2023
WAGAN Corp. Limited Warranty
31088 San Clemente Street
Hayward, CA 94544, U.S.A.
Tel: +1.510.471.9221
U.S. & Canada Toll Free: +1.800.231.5806
www.wagan.com
REV20230601
©2023 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
Table of contents
Other Wagan Power Tools manuals
