Wali 1742LM User manual

55lbs
(25kg)
Please confirm that your TV
weight do not exceed 25kg
Warning:Please do not
exceed the maximum
load-bearing capacity, which
may cause equipment failure.
.
For 17”-42”
62-480mm
Full-featured TV Bracket
What material is your wall made of?
Is it a wood wall? Please read the instructions thoroughly and have a good understanding of the entire
installation process. Reading the instructions for your TV to see whether there have
any special instructions for using the brackets or not.
WARNING: Avoid potential personal injury and property damage.
1. Please check your wall fastness, suitable for general wood and brick, not
plasterboard wall
2. The wall must be able to carry 5 times the weight (total of the TV plus the bracket)
3. Our company does not bear the loss and damage caused by improper use.
Confirm the VESA distance of the
hole on the back of your TV.
Installation step 1 Installation Step 2
Please confirm your TV hole pitch is
100x100mm or 200x200mm
Model:1742LM
Installation tools
Screwdriver Pencil
Impact Drill 10MM Drill Bit Wrench
Parts List
①
Bracket (x1)
②
Punched cardboard (x1)
③
Cable tie*3
Self-tapping screw (x4)
A
M4*20 (x4)
C
M5*25 (x4)
D
M6*25 (x4)
E
M8*25 (x4)
F
big spacer (x4)
G
small spacer (x4)
H
D5 gasket (x4)
I
D6 gasket (x4)
J
Stud Finder
Plastic ancher (x4)
B
Bubble (x1)
K

Need someone to carry the TV
TV back TV back / Extension washer
Installation step 4 wall mounting
Please make sure the wall is safe and
then install as shown .
Use a stud finder to find out if there
are other wires in the wall, and install the
base as far as possible to avoid the
wires.
Use a pencil to draw the installed hole on the wall
and use the level to ensure the level.
Installation step 5
4-1 4-2 4-3
Remove the pre-installed screws.
As shown in the picture, the TV is
hooked into the head frame and
pushed in.Then screw back in the removed screw. Complete the installation as shown
AB
M5 M6 M8
Installation step 3
Use screws below
Warning: Correct screw
and washer usage
- Too short to fix the TV
- Too long to damage the TV
The method of
connecting the TV,
A or B which is
shown in figure 1.
Make sure your screw
is right on this TV
hole to screw into the
TV. Safely tightening
screws can be used
with or without
washers. Make sure
the screws are
tightened before
proceeding to the
next step.
Short Long
Correct
If it is a wood wall, please use the self-tapping
screw A directly. If it is a cement wall, please
firstly insert the plastic anchor B into the wall,
then tighten with the self-tapping screw A.
Use the cable tie 3 to complete the routing