Waterhouse XC-SP2502 User manual

12 Volt Hot Water Circulation Pump User Guide Manual
Model: XC-SP2502
Caution:
Please read all instructions carefully before installing this product.
This pump is not ip68 sealed and therefore shall by any means never be submerged.
However, the electric wire connections must not be submerged. For extra protection please
insulate all joins and ends with approved insulation or shrink tapes to avoid electric shocks
and fire sparks that may cause explosions or fires.
Security:
•12V brushless pumps can only be used for pumping clean cold and hot water and
non-corrosive chemicals and liquids.
•Please connect pump’s black and white wire to the negative terminal (-) and white
wire to the positive terminal (+).
•Make sure you use suitable size fuses.
•The wire connections must be insulated by shrink or watertight insulation tape.
•All wire connections must be outside water, unless necessary provided you have an
ip68 waterproof connector.
•Please do not run the pump dry.
•Your pump must always be protected from water splashes or any liquid chemicals.
•Make sure the pump works in a ventilated environment.
About product:
•Circulation pump is non-self-priming pump. Max Flow Rate: 25L/MIN, Max Discharge
Head: 3M
•20mm male adapter on the pump.
•Power source: DC 12V (NOT INCLUDED), Rated current: 2.0A, Brushless Motor, Low
noise: 30db at 1 metre, Service life: 30000 hours.
•Max circulating water temperature: 100°C
•Do no submerge.

Specifications:
Model
Flow Rate
Volt
Current (A)
Head (m)
Cable
Outlet Dia
Weight
XC-
SP2502
25L/MIN
12
2.0AMP
3.0
20cm
20mm
0.25kgs
Warning:
•To prevent injury, always disconnect the power source when installing or servicing
any electric product.
•Do not use the pump-to-pump gasoline oil or any flammable liquids.
•Always make sure you use fuse amperage rated for your pump model.
•Failure to follow these instructions may result in serious injury or fire hazards.
Optional Materials:
•Mounting screws
•Mounting brackets.
Pump Mounting Instructions:
Warning: remove any polystyrene or foam blocks covering the pump around for
shipping purposes.
•Step 1: make sure you mount the pump wit5h safety brackets, make sure it is
holding firmly as to avoid too much vibration that will affect your seals and bearings.
•Step 2: now insert your hose inlet/outlet and use hose clamps to secure the pipes.
•Step 3: now you can link your inlet pipe to the water source and outlet to the supply,
you must always watch for the inlet/outlet arrow when installing this type of pump.
•Step 4: make sure your pump is at bottom of the water level as is the pump is not
self-priming.
•Step 5: make sure you pump is covered or protected from water or rains never
submerge the pump.

Pump mounting:
Operation:
1. Connect your -+ terminals accordingly to your battery positive and negative poles.
2. Make sure you have right size fuse on your positive pole.
3. Connect your pump to the control switch, depending on what operation you are
using the pump for:
•Use manual or thermostat switches for pump control.
Care & Maintenance:
•Always watch your power supply voltage or current for over voltage, under voltage
or short circuit.
•Make sure your pump filter sieve is always clean of debris or any clogging dirty.
•Careful attention will guarantee outstanding pump performance

Parts:
For more information, please feel free to contact us on 011 466 8520 or email
us at [email protected]a