1 2
3 4
IMPORTANT WARNING AND SAFEGUARDS
Age Recommendation: 18 years or over. Not a toy. Not intended for
use by children without direct adult supervision. As the user of this
product, you are solely responsible for operating it in a manner that
does not endanger yourself and others or result in damage to the
product or the property of others.
Warning! Buyer/user assumes all
responsibility for safety and proper use
not in accordance with the directions
and safety labels.
PART LIST
1. 2 x Stand mounting bracket 33.5”
2. 2 x Adjustable extension 37.5”
3. 2 x Light mounting arm 28.25” x 10.65”
4. Set of Wave-point light hanging kit item 10374
5. 6 x 1.25” screws with nut
6. 8 x 1” screws
INSTRUCTIONS FOR INSTALLATION
Required tools for installation:
Level, Philips screw driver and Small drill for pilot hole
Instructions for installation:
1. Position the stand mounting brackets on the back of the
stand. Make them equal distance from the edge of the stand
and so that the light hanging kit is a minimum of 2” from the
edge of the hood.
2. Now use the level to verify that they are straight. Depending
on the stand design it may be necessary to install shims to
level the unit.
3. Mark holes
4. Drill small pilot holes
5. Secure to with 1” screws stand
6. Slide the adjustable extension into the stand mount bracket
and secure with the 1.25” screws and nuts
7. Slide the light mounting arm into the adjustable extension
and secure with the 1.25” screws and nuts
8. Adjust height as needed
Hanging light
9. Loosen the cable stop and remove from the cable
10. Slide the cable through the holes in the light mounting arm
11. Choose the desired height of the xture
12. Cut wire to equal distances and secure with the cable stop
13. Slide mounting bracket onto the track of the light hood.
Position them equal distance from the edge of the light
hood. The bracket in the track should be a minimum of 2”
from the edge of the light hood
14. Press down the button on the mounting bracket to level
If using other hanging kits follow their instructions
and guidelines
Wave Point®Technology
www.wave-point.com
©2012 Wave Point®Technology
Photo: ©Wave Point®. ©Greg Rothchilds
All rights reserved
Specications are subject to change without notice
●Stainless steel construction
●Adjustable from 59in to 79in
●For use on 20in or 24in wide aquariums
●Welded mounts that connect directly to
the stand
●Mounting hardware included
●Wave Point 4 lamp hanging kit included
