Manual SECUR
Page: 3 / 9
Marking of switches, objects, etc. in the illustrations of these operating and operating instructions.
4 Regulations for the use of the slab stand
Please pay close attention to the information on the use of the machine or the device.
Caution, danger of injury!
Improper use leads to personal injury !
The device or machine is specifically designed for one or more applications.
The following chapters are intended to give you an understanding of these possible applications and to
highlight the dangers involved in using the work equipment. Areas of application
You have purchased a quality product from WEHA-Ludwig Werwein GmbH.
The slab stand is a tool to help you store stone slabs and make your job easier.
The following features are particularly noteworthy:
- Safe and easy storage of flagstones
- Painted surfaces
4.1 Improper use
The slab stand is used for the outstanding storage of stone slabs up to a maximum total weight of 5000 kg.
Use the slab stand for the area and the number of elements that can damage the metal or the individual assemblies!
4.2 Safety regulations
The slab stand is completely and specially designed for the application areas.
• The two A-stands of the slab stand must be set up parallel and at right angles to the surface of a rectangle.
• The stone slabs must be placed parallel to the trestle. Slanted placement of the stone slabs, ie the stone slabs do not rest on both
support frames, is not permitted!
• The stone slabs must be adjusted centered.
• The stone slabs must be moved carefully in the slab stand.
• The stone slabs may be a maximum of 2m high and a maximum of 3.2 m wide! Safety regulations
x• Read these operating instructions thoroughly before using the plate stand!
• Store the operating instructions carefully near the plate stand for all future cases of doubt!
• The unconventional modification or the installation of additional equipment leads to the cancellation of any liability claim
by the dealer or manufacturer!
• Remove all objects from the work area which could be a potential source of danger!
• The plate stand may only be used by authorized persons. Every user must have read and understood this
documentation.
• Check the load-bearing parts and welds for damage before each use! If defects are found, the use of the plate stand must
be discontinued and use by third parties must be prevented by suitable measures.
• Make sure that the surface on which you place the plate stand has sufficient load capacity!
• The substrate under the support profiles must have sufficient load-bearing capacity!
• The maximum permissible load on each of the two sides is 5 T on each side when loaded evenly.
• The stone slabs may be a maximum of 2m high and a maximum of 3.2 m wide! It is important to ensure that the stone
slabs are adjusted centered.
• The stone slabs must rest against the trestle over the entire height of the A-post, which corresponds to a slope of 6 °.
• The stone slabs must be placed parallel to the support frames. Slanting the stone slabs, that means the stone slabs do
not rest on both support racks, is not allowed!
• The stone slabs must be moved carefully in the plate stand.
• Staying under suspended loads is prohibited!
• Keep the work area clean and ensure adequate lighting!
• Always wear appropriate protective clothing when handling the plate stand, in accordance with the applicable
regulations!
• These includes:
• Work gloves and work clothing according to the applicable regulations, also for accident prevention!
• Footwear according to the applicable regulations, also for accident prevention!
• Only use workpiece materials suitable for the properties of the device, such as stone plates without cracks ("healthy"
stone plates)!
• Make sure that nobody is in the vicinity of the device during use in order to exclude any danger to third parties!
• Check if all parts are mounted correctly!
If damage or malfunction occurs on the device, please contact the dealer or manufacturer immediately!
D2
