Welbilt Convotherm 3432600 User manual

Hood with front extraction Read instructions before use
mini Condensate Hood Pro
Operating and installation instructions CE - Original, ENG

Table of Contents
1 General information 5
1.1 EC Declaration of Conformity 5
1.2 Environmental protection 6
1.3 Identifying your hood 7
1.4 Essential reading relating to safety 8
1.5 About this operating and installation instruction 9
2 For your safety 10
2.1 Basic safety code 10
2.2 Intended use of your hood 11
2.3 Warnings on the hood 12
2.4 Hazards and safety precautions when moving the appliance 13
2.5 Hazards and safety precautions during assembly and pre-installation 14
2.6 Hazards and safety precautions during installation 16
2.7 Hazards and safety precautions when putting the appliance into service 18
2.8 Hazards and safety precautions during operation 19
2.9 Hazards and safety precautions during cleaning 20
2.10 Hazards and safety precautions during servicing 21
2.11 Hazards and safety precautions during retrofitting 24
2.12 Hazards and safety precautions when removing the appliance from service 25
2.13 Safety devices 26
2.14 Requirements to be met by personnel, working positions 27
2.15 Personal protective equipment 28
3 Transport 29
3.1 Working safely with the appliance 29
3.2 Bringing the appliance to its installation location 30
4 Assembly and pre-installation 31
4.1 Safe working during assembly and pre-installation 31
4.2 Requirements for the installation location 33
4.3 Requirements relating to the configuration of the combi oven 34
4.4 Contents of the installation kit 35
4.5 Basic sequence for installation 36
4.6 Connecting the control cable to the appliance 37
4.7 Attaching the rear adhesive fixing element 40
4.8 Fitting the hood 41
4.9 Connecting the hood 43
4.10 Fitting the hood front 44
4.11 Fitting the baffle filter 45
5 Installation 46
5.1 Safe working during electrical installation 46
5.2 Electrical installation 47
6 Putting into service 48
6.1 Safe working when putting the appliance into service 48
6.2 Procedure for putting the appliance into service 49
Table of Contents
Operating and installation instructions 3

7 Operation 51
7.1 Safe working when operating the appliance 51
7.2 Basic operating sequence 52
8 Cleaning 53
8.1 Safe working when cleaning 53
8.2 Cleaning tasks 54
8.3 Remove the baffle filter 55
9 Servicing 56
9.1 Safe working when servicing the appliance 56
9.2 Servicing tasks 58
9.3 Basic procedure for removal 59
9.4 Troubleshooting 60
10 Retrofitting 61
10.1 Safe working during retrofitting 61
10.2 Drilling a hole in the connecting bracket 62
10.3 Checking and replacing the control module 65
10.4 Checking and updating the software version 67
10.5 Checking and updating the flap control 68
11 Removal from service 69
11.1 Safe working when removing the appliance from service 69
11.2 Procedure for removing the appliance from service 69
12 Technical data 71
12.1 mini Condensate Hood Pro technical data 71
Table of Contents
Operating and installation instructions 4

1 General information
Purpose of this chapter
This chapter provides information about using these operating and installation instructions.
1.1 EC Declaration of Conformity
Manufacturer
Convotherm Elektrogeräte GmbH, Welbilt, Talstraße 35, 82436 Eglfing, Germany
Validity of Declaration of Conformity
This Declaration of Conformity applies to the following hood:
mini Condensate Hood Pro 6.06 6.10/10.10
Declaration of Conformity with directives
The manufacturer hereby declares that the condensation hoods listed above comply with the following
directives:
■2006/42/EC (Machinery Directive)
■2011/65/EU (RoHS Directive)
The safety objectives of European Directive 2014/35/EU (Low Voltage Directive) have been met in ac‐
cordance with Annex I, Section 1.5.1 of the Machinery Directive.
Compliance of electric appliances with standards
The electric appliances comply with the requirements in the following European standards:
■EN 61000-3-2: 2014
■EN 55014-1: 2006 + A1: 2009 + A2: 2011
■EN 61000-3-3: 2013
■EN 55014-2: 1997 + A1: 2001 + A2: 2008
■EN 60335-2-99: 2003 + AMD1: 2017
■IEC 60335-1 2010 + AMD1: 2013
■IEC 62233: 2005
Authorized body for documentation
The following body is authorized to compile the technical documentation in accordance with Annex II A
Section 2 of Directive 2006/42/EC: Convotherm Elektrogeräte GmbH, Wellbilt, Talstraße 35, 82436
Eglfing, Germany.
Eglfing, 23.07.2019
Reine Wasner
Managing Director
i.V. Gisela Rosenkranz
Manager Product Compliance and
Technical Communication
1 General information
Operating and installation instructions 5