WESTEK BL-PUTN User manual

BL-PUTN Ultra-Thin Puck Light Owner’s Manual
Battery Installation
1. To open, when looking at the back, twist back cover counter-clockwise
and remove.
2. Insert 3 AAA batteries (follow the illustration inside the battery compartment).
Ensure the batteries are inserted so that the at ends are making contact
with the springs.
3. To close, replace the cover and turn clockwise.
Operation
Tap the lens once for on, tap again to dim, and a third tap
will turn off the light.
Light Installation
Determine mounting location and type of mount

CAUTION: Be cautious of what surface the adhesive is attached, as it may
remove paint or damage surface.
Mounting with double-sided 3M adhesive tape
1. Peel and remove one side of the tape backer to expose adhesive
and rmly attach centered in the back of puck.
2. Make sure the area where you want to attach the light is clean and clear of
debris and dust.
3. Peel and remove the other side of tape backer and place the puck in the
desired mounting location. Firmly press the adhesive tape against your
surface to mount the light.
Mounting with screws
1. Remove the back of light by twisting counter-clockwise.
2. Use the two holes in the back as a guide to drill pilot holes.
3. Secure the back to your mounting surface with included screws –
do not overtighten.
Limited Warranty
Under normal use and conditions, AmerTac provides to the original purchaser of this
product a one year limited express warranty that is set forth in the Limited Warranty
stated in full at www.amertac.com/warranties. The Limited Warranty is in lieu of all
other express or implied warranties or liabilities subject to the exceptions explained fully
in the Limited Warranty on the website.
©2021 AmerTac™
250 Boulder Dr.
Breinigsville, PA 18031
610-336-1330
www.amertac.com
Made in China
BO_TL_044_1120