Whirlpool Thin Twin LT4905XM User manual

-
tt
.
II
n
.
Wit-
WASHER l DRYER
Model LT4905XM
wave Ovens. Trash Compactors. Room Air Condltionerr. Oehumldlfiers. Automatic Washers, Clolhes Oryers. freezers. Refrigerator-Freeze

Parts and features
LINT SCREEN
DRYER DRUM
WASHER CONTROLS
SELECTOR SWITCH
DRYER CONTROLS
WASHER LID LATCH
gF’;Lq-JAL EXHAUST
LINT FILTER
BASKET
AGITATOR
TUB
Remove the Consumer Buy
Guide label. It will be easier
to remove before the
washer l dryer is used.
You should wipe out the
washer basket and dryer
drum with a damp cloth be-
fore using to remove dust
from storing or shipping.
L
Copy your Model and Serial Numbers here
When you need service or call with a
question, have this information ready:
1. Complete Model and Serial Num-
bers (from the plate located OS
Complete Model Number
shown).
2. Purchase date from sales slip.
Complete Serial Number
Copy this information in these spaces.
Keep this book. your warranty and sales Purchose Dote
slip together in a handy place. There
is no warranty registration to return.
Service Company and
Proof-of-purchase is all that is required Telephone Number
for in-warranty service.
2

Contents
Page Page
Your Responsibilities. 3 lint Screen,, 14
Safety 4 lint Removal,. 14
Before Using Your WASHER
l DRYER
Washer l Dryer. 5
WASHER Caring for Your
Washer l Dryer.. 15
Starting Your Washer.. 6 Cleaning Dryer Interior 15
What Happens in Each Vocation Care 16
Cycle.. 8 Winterizing 16
Other Operating If You Need Service or
Instructions 10 Assistance. 17
Cleaning the Lint Filter.. 10 1. Before Calling for
DRYER Assistance 17
Starting Your Dryer. 11 2. If You Need Assistance 18
Selecting a Cycle. 12 3. If You Need Service 18
Drying Tips.. 13 4. If You Have a Problem 18
m,nor \A,ki~lr.rr~l ~..~r.rr~-+iAw.
Your responsibilities
Read thisUse and CareGuide”and your”Laundry Guide”
carefully for important use and safety information.
You are personally responsible for Installation. Have your
washer /dryer installed by a quallfled installer and make sure that
it has been..
1. Installed exactly according to the”lnstallation Instructions,”
including _.
l proper electrical supply, outlet and grounding;*
l proper water supply, plumbing fixtures and drain;*
. proper dryer exhausting system. *
2. Installed and leveled in a room where..
l there is adequate ventilation and protection from weather;
l the floor is strong enough to support the weight;
l The temperature is above 4BF (7.2 C] because..
-the dryer will not operate properly at cold temperatures.
-freezing temperatures can damage the washer.
*Refer to the”lnstallatlon Instructlons”for complete informatlon.
You are personally responsible for proper use of your
washer /dryer. You must be sure that it is.. .
1. Used only by those who understand how to operate it properly.
2. Properly maintained and used only for jobs expected of home
washers and dryers.
You are personally responsible for the safe use of your
washer /drver.
DO NOT try to service
this appliance unless it
is unplugged or the
electrlcal power has
been turned off.

Before using your
THIN TWIN*
washer l dryer
For best washing and drying results, you must take some very important
steps before, during and after each load:
1. Prepare and sort each load for washing (“Laundry Guide,” pages 4-5).
2. Measure and add detergent or soap to washer (“Laundry Guide,” pages
9-10).
3. Load the washer properly (“Laundry Guide,” pages 6-7).
4. Select the water temperature, load size and cycle recommended for the
fabrics before starting the washer (“Use and Care Guide,” pages 6-7).
5. Add other laundry aids to the washer according to instructions (“Laundry
Guide,” pages 11-13).
6. Properly sort the load for drying (“Laundry Guide,” pages l&19].
7. Select the right drying cycle and time for the fabrics (“Use and Care
Guide,” page 12).
8. Remove and hang or fold items lmmedlately after drying.

Starting your washer
Before starting your washer, be sure you have measured and added
detergent, and have put in a properly sorted load as recommended in
Your “Laundry Guide:’
Position
1. SELECTOR SWITCH
l Move Selector Switch to WASHER
position. Washer will not operate
when switch is in DRYER position.
Select WATER
3. TEMPERATURES
*Match the wash water temperature
to the type of fabrics and soils being
washed.
Recommended wash temperatures
can be found in your “Laundry Guide:’
6
l Turn the knob to point at a setting
that describes the size of load you
want to wash.
l The water level can be set for EX
SMALL, MEDIUM or LARGE loads.
Select the water level that
matches the load size.
See your “Laundry Guide” for details
on load sizes.
LOAD SIZES AND WATER LEVELS
For best cleaning results, the
load must be able to move freely
in the water. Too big a load or too
little water can tear items.
‘Approx~mole 1111wth load

Select CYCLE and WASH TIME;
4. Start the washer
A. Push in the Control Knob and
turn it to the right. It must be
pushed in and turned only
clockwise.
B. Stop on a number in the cycle
you want. The numbers are
minutes of wash time The
drawing shows 8 minutes of
agltatlon In the REGULAR HEAVY
Cycle.
C.
Start the washer by pulling out
the Control Knob. The washer
will fill to the level you set with
wash water of the selected
temperature. After filling, the
washer will agitate far the
selected number of minutes.
D. To stop the washer at any time,
push in the Control Knob. To
restart the washer, pull out the
Control Knob.
To set the controls for a rinse and spin,
a drain and spin, or a soak or pre-
wash, see page 10. 7

What happens in each cycle
Each cycle has different agitation and spin speeds designed for different
kinds of fabrics. Numbers on the dial in each cycle are the minutes of WASH
agitation time.
When the Cycle Control Knob is set to a number and pulled outthe washer
fills before agitation and timing starts, After agitation starts, the knob turns
REGULAR HEAVY Cycle
PERMANENT PRESS Cycle
ff 10 4
permanent
press
iii&II
.
1 A special cycle with the
necessary cool-down rinse FILL
which helps keep wrinkles nr
w&d
from setting into Permanent level
Press and some synthetic
fabrics.
KNITS/GENTLE Cycle
SOAK Cycle
1
Off
m
soak
4
14 22 f
WASH
Selt3cted
, Time;
n High Speed
A cycle that gently washes
and spins delicate items
and washable knits. Wash
nylon hose in a net laundry
bag.
--
Periods of agitation and
soaking time help remove
heavy soils and certain
stains that need extra
pretreatment. Use recom-
mended amount of de-
tergent. The SOAK Cycle
should always be followed
by a Wash Cycle.

clockwise until it points to OFF and the cycle ends.
NOTE:You may hear the sound of water spraying during the spin parts of
some cycles. In some cycles. cold water is sprayed on the spinning load to
help with the rinsing.
NOTE: Always use cold rinse water for
permanent press fabrics.
I
+ Pre-wash setting begins here (see pagelo)
Special care is needed when soaking or pre-washing laundry.
See your “laundry Guide” for proper use of this cycle. I
9

Other operating instructions
For a rinse and spin
I .- 22bfr D”Shstop
For a drain and spin
You may need an extra rinse and Your washer can be set to drain
spin for heavily soiled loads which and spin out water.
need more detergent. (Extra de-
l Push Control Knob in.
tergent can require an extra rinse.) 0 Turn ClOCkwIse to the bar lust before
l Push Control Knob in. OFF. See above drawing.
l Turn clockwise to any.on the dial. l Pull Control Knob out.
See above drawing.
l The washer will drain and spin.
l Pull Control Knob out.
l The washer will fill to selected level
with cold water, agitate 2 minutes,
drain and spin.
For agitation and spin speeds in each cycle, see pages 8 and 9.
For a soak or pre-wash
For best results, use warm water
for soaking or pre-washing soiled
laundrv.
l Use enough detergent or pre-soak
product for a single load.
l Push Control Knob in.
Turn clockwise to point at a number
in the SOAK CYcle.
Pull Control Knob out.
When the cycle is over, add de-
tergent for the next selected wash
cycle. Important: See additional
care intormation on page 7 of your
“Laundry Guide!’
Set the washer and start the next
selected wash cycle.
To start the soak or pre-wash with agitation, the Cycle Control
Knob must point to a number in the SOAK Cycle.
Cleaning the lint filter
Water runs through the lint filter
whenever the washer agitates.
Check it often to make sure it’s clean
and is filtering at its best.
To remove it for cleaning, press the
release and pull straight out. Instruc-
tions for cleaning are printed on the
bottom of the filter.
10