Wikk Wireless REC 1 CHAN 433 User manual

REC 1 CHAN 433
1 CHANNEL NANO RECEIVER
programming button.
operators
Thank you for choosing a Wikk Wireless product.
2 x 1¼ x ¾ inches
Adjustable Voltage
P1
(approx. 3 seconds)
program the receiver will beep to
The receiver will allow additional transmitters to be programmed for 5 seconds.
After 5 seconds, the receiver will beep and the programming procedure ends.
verify program.

5 - PROGRAMMING THE ADJUSTABLE TIME HOLD FEATURE
1. Press and hold P1(program button) on the receiver until buzzer beeps
(approx. 3 seconds).
2. Quickly release program button and immediately press and release the program
button for the number of seconds of hold time.
3. Wait 5 seconds for recever to exit program mode.
Example:
PR + PR + PR + PR + PR = 1 + 1 + 1 + 1 + 1 = 5 sec. adjustable hold time
(PR = Press - Release)
(approx. 3 seconds)
program the receiver will beep to
The receiver will allow additional transmitters to be programmed for 5 seconds.
After 5 seconds, the receiver will beep and the programming procedure ends.
verify program.
programming
program pressing
P1 - program button
when the relay is activated.
8
(Maximum hold time is 20 seconds.)
The warranty period of the receiver is twenty-four (24) months. This warranty shall begin on the
date the receiver is manufactured. During the warranty period, the product will be repaired or
replaced (at the sole discretion of the manufacturer) if the product does not operate correctly due
to a defective component. This warranty does not extend to (a) the receiver case, which can be
damaged by conditions outside the control of the manufacturer.
programming
NOTE: The programming of a new transmitter without using the P1 button can only
be done using a transmitter that has already been memorized. Use the memorized
transmitter to open the memory (Step 1 and 2). Complete the procedure by
pressing the key of the new transmitter to memorize.