WARNINGS & SAFETY INSTRUCTIONS
Do not operate WiTi unless you have read and understood this manual and WiTi
is installed as per the instructions.
• Ensure the cable used to install WiTi Anti-Theft is of adequate thickness to provide the
necessary current for the circuit.
• WiTi Anti-Theft must be installed away from environmental conditions that may cause
damage to the unit’s circuitry including water, salt spray and humidity.
• WiTi
functions.
• WiTi automatically pairs when in range but it is always good practice to check the lights
before towing to ensure they are all operating.
• The condition of the battery in the caravan or trailer must be maintained and checked and
• It is recommended to remove power from the Vehicle Unit if it is going to be in storage or
unused for a period longer than 2 weeks. Whilst the Vehicle Unit only draws 80 milliAmps
battery receiving a charge.
• NOTE : When servicing the caravan or trailer it is recommended WiTi is disconnected
to prevent accidental short circuits when servicing the electric brakes or magnets.
WITI WIRELESS INTERFACE
WiTi replaces the cables connecting a tow vehicle and trailer or caravan with an advanced
wireless interface. WiTi consists of a primary unit in the tow vehicle and a secondary unit in
the trailer or caravan. WiTi transmits all lighting and braking signals from the tow vehicle to
the caravan or trailer wirelessly. WiTi complies with Australian Design Rules when installed as
directed.
WiTi
WiTi
when hitched. These features will be enabled when the vehicle unit and trailer unit are in range
Transmission of lighting signals is disabled when the alarm is activated on the trailer.
LOW VOLTAGE ALARM
WiTi features a low voltage alarm. If voltage drops below 11.5V on the battery in the trailer or
to the Anti-Theft alarm. WiTi must be connected to a charging source immediately in order to
suspend the low voltage alarm.
