Woodbridge Wk090802 Assembly instructions

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

www.woodbridgebath.com 1

R

WOODBRIDGE

INSTALLATION AND CARE GUIDE

READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT

This products must be installed by a fully insured and licensed plumber only. Installation of any our product by anyone other

than fully insured and licensed plumber shall void limited warranty. We recommends that such licensed plumber has experience

in the installation of products.

Limited warranty is void on any commercial installation

We are not responsible for local code compliance for this product. Building and plumbing codes may vary from state-to-state in

accordance to your location. We are not responsible for providing any compliance certiﬁcations.

Under no circumstances we shall not be liable for any incidental damages sustained in connection with this product

Neither manufacture, nor distributor, nor retailer is responsible for water damage or ﬂood caused due to use of this product.

Under no circumstances We shall not be liable for any and all fees, cost of installation/reinstallation/removal, subsequent

damage or transportation in case of the product defect

Certiﬁed to the following Codes & Standard:

®

• ASME112.18.1-2018/CSA B125.1-18

• NSF/ANSI/CAN 61-2018

KITCHEN FAUCET

WK090802

Customer Service Phone: 562-229-0088. (Monday - Friday 9 AM - 5 PM Paciﬁc Time)

Or Email: [email protected]

20201005 REV. 1

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

www.woodbridgebath.com 2

DIMENSION DRAWINGS:

R

WOODBRIDGE

YOU MAY NEED

KITCHEN FAUCET

420

16-1/2"

230

9"

30 MAX

1-1/8"

160

6-1/4"

224

8-3/4"

68

2-5/8"

246

9-5/8"

32

1-1/4"

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

www.woodbridgebath.com 3

KITCHEN FAUCET

PARTS & COMPONENTS

R

WOODBRIDGE

PARTS:

N0

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

Component

Body

Washer

Spray Head

Cartridge

Press Hat

Cap

Handle

Screw

Canopy

deck plate

Screwed Pipe

O-Ring

Washer

Lock Nut

Pilot Sleeve

Washer

Flexible Hose

Hose Weight

If you’ve followed the instruction carefully and your faucet still does notwork properly, take these corrective steps.

TROUBLE-SHOOTING

Problem Cause Action

Leaks underneath handle.

Aerator leaks or has an

inconsisitent water flow pattern.

Water willnot shut off

completely.

Cartridge has come loose.

Aerator is dirty or worn

out or misfitted.

Dirty or worn out washer

in cartridge.

Tighten the cartridge.

Unscrew the aerator to clean orreplace

washer, or replace the aerator.

Remove handle and cartridge to check

if the washer is damag permanently or

dirty. Re-install cartridge.

1

2

3

456

11

12

7

8

13

14

10

9

17

16

15

18

19

20

21

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

www.woodbridgebath.com 4

R

WOODBRIDGE

INSTALLATION PROCEDURES

KITCHEN FAUCET

1

2A 2B

Warning!!!

Do not over-tighten nut during installation.

Over-tighten may crack the valve and cause severe leak.

2

3

If necessary, tighten screws using a adjustable

wrench until the faucet is firmly connected to the

sink.

4

install brass adapter to the hose inlet from below, Connect

hot and cold water supply lines to the Water Supply Valves.

Rubber Washer

Metal Washer

Locknut

You should clean all the dirts from valve outlets.

Turning off the water supply valves.This is usually

found near the water meter.If you are replacing

an existing faucet, remove the faucet from the

sink and clean the sink surface thoroughly.

Installation without deck plate, make sure the O-Ring is placed

into the bottom of base ring, install faucet through hole on sink.

From underneath of the sink, insert rubber washer, metal

washer and lock nut onto screwed pipe. Position faucet on

sink properly and hand tighten locknut.

Installation with deck Plate, apply a bead of plumber’s putty

between faucet and sink, place deck plate over the three holes

on sink, tighten with wing nuts from underneath sink.

Make sure the O-Ring is placed onto the bottom of base ring,

insert faucet through deck plate, from underneath of the sink,

insert rubber washer, metal washer and lock nut onto screwed

pipe. Position faucet on sink properly and hand tighten locknut

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

R

WOODBRIDGE

www.woodbridgebath.com 5

R

WOODBRIDGE KITCHEN FAUCET

INSTALLATION PROCEDURES

Replace Spray head.

5 6

Handle Removal Maintenance Valve Cartridge Removal Maintenance

7

After installation is complete, remove Spray head

and rotate handle to the close position. Turn

Water Supply Valves on, and check all connections

for leak. Flush faucet by running hot and cold

water in full position for one minute.

Turn off water and relieve pressure! Detach handle button

using a small flathead screwdriver, unscrew set screw

using Allen Wrench and take off handle.

Remove handles. Unscrew Dome Cap counter clockwise

by hand. Unscrew Retaining Nut using adjustable wrench,

take out cartridge assembly and inspect. Replace parts

as necessary. Reassemble parts by reversing steps.

8

Hot

Open

Close

Cold

Lift the handle up, the cartridge will be activated and allowing

water to flow, the water flow will increase by continuing to rotate

handle. When handle is on the right side of the faucet, water

temperature will become cold when handle is rotating backward

and water temperature will become hot when handle is rotating

forward.

Attach Weights to the pull-out sprayer hose and secured screws

to the holes on the Weights.

Woodbridge WK090802 Assembly instructions

Popular Kitchen & Bath Fixture manuals by other brands