XAiOX InstantFix User manual

User’s Manual XAiOX InstantFix Bluetooth GPS Receiver - 1 –
User’s Manual
Bluetooth GPS Receiver
XAiOX InstantFix
Copyright©2005 XAiOX Technologies
All rights reserved

User’s Manual XAiOX InstantFix Bluetooth GPS Receiver - 2 –
Contents
1. Introduction ………………………………………………………………………………………………………. 3
1.1. Overview …………..………………………………………………………………………………………. 3
1.2. Main Features ……………….…………………………………………………………………………. 4
2. Technical Specification ……………………………………….….……………………………………….. 5-6
3. Hardware Description ……………………………………………..………………………………………… 7
4. Important Notes ……………………………………………………………………………………………….. 8
5. Box Contents …………………………………………..………………………………………………………… 9
6. Software-Installation – Pocket PC CE …………………………………………….……………….. 10-13

User’s Manual XAiOX InstantFix Bluetooth GPS Receiver - 3 –
1. Introduction
1.1 Overview
The XAiOX InstantFix GPS Receiver is a Global Position System Receiver with Bluetooth
wireless technology. This BT GPS receiver allows you to receive GPS data on mobile
handhelds wirelessly. By sending >GPS position data over Bluetooth, you can position
the receiver for the best possible reception all without wires. The advent of Bluetooth
GPS receiver will become the next level of GPS receivers. The BT GPS receiver integrates
Bluetooth module into GPS device. It shows the high performance, low power
consumption, easily portable, rechargeable and removable battery function and wireless
data transmission. If you have a Pocket PC or other portable devices enabled with
Bluetooth function for example iPaq, Siemens Loox, HP, MDA, XDA, you can take
advantage of your device’s Bluetooth capability to wirelessly add GPS positioning
technology. When you choose suitable navigation software, you can apply to personal,
vehicle tracking, and marine navigation. If you use this Bluetooth GPS receiver, you will
ignore the messy cords and antenna and add the portability of your Pocket PC. In
addition, this Bluetooth GPS receiver can change the exhausted battery to full battery
like battery of mobile phone.

User’s Manual XAiOX InstantFix Bluetooth GPS Receiver - 4 –
1.2 Main Features
•32 Channels ‚All-in-view’ Tracking.
•Cold/Warm/Hot Start Time: 43/25/4 Seconds
•Re-Acquisition Time: 0,1 second
•Supports Standard NMEA-0183 at 9600/38400 bps baud rate
•Compatible with Bluetooth Devices with Serial Port Profile (SPP)
•Small, sleek, and lightweight design easily fits in your hand
•Two LEDs on top of the device shows Bluetooth and GPS. There also is an
ON/OFF button.
•Fleet Management/Asset tracking
•Personal/Portable Navigation (PDA, Pocket PC etc.)
•Location Based Service enabled devices
•Ultra low power up to 12 to 15 hours operation time after fully charged
(1000mA Li-Ion Battery) or up to one week in standby mode.
•High sensitivity -157dBm integrated GPS Receiver, active antenna and
Bluetooth transceiver

User’s Manual XAiOX InstantFix Bluetooth GPS Receiver - 5 –
2. Technical Specification
GPS Chip:
Frequence:
C/A Code:
Channels:
RFMD GPS Module
L1, 1575, 42 MHz
1,023 MHz Chip Rate
32
Antenna: Built-in low noise
(External Antenna optional)
Ext. Antenna Port MMCX-Antenna
Acquisition Rate:
Cold Start:
Warm Start:
Hot Start:
Snap Start:
Re-Acquisation:
Update-Interval:
approx. 43 Seconds
approx. 25 Seconds
approx. 4 Seconds
approx. 1 Seconds
approx. 100 mSec
Each Second (default)
Accuracy:
Position:
Velocity:
Time:
Open Sky <5 m, CEP (90 %)
Indoor <20 m
0,1m/sec
100 ns synch. to GPS time

User’s Manual XAiOX InstantFix Bluetooth GPS Receiver - 6 –
Bluetooth Protocol:
Communication:
GPS Protocol:
Baudrate:
Bluetooth serial
Distance up to 10 m
NMEA-0183(V3.01) VTG, GGA, GSA,GSV,RMC
9600/38400 bps (Data Bit: 8, Stop Bit: 1)
Battery: Rechargeable 1000mA/h Lithium-Ion Battery
Charging time: approx. 2.5 hours
Operation time: approx. 12 to 15 hours, after fully charged
Standby: up to one week
Operation Current: 5V
Operating temperature: -20 °C to +60 °C
Rel. Humidity: 5 % to 90 % (non-condensing)
Altitude: <18.000 m
Dimensions:
Length:
Width:
Hight:
81 mm
43 mm
17.6 mm

User’s Manual XAiOX InstantFix Bluetooth GPS Receiver - 7 –
3. Hardware Description
LED Status Table
LED Farbe Status
GREEN OFF Unit is switched OFF
GREEN ON Unit is switched ON, ready for SAT reception
LED1
SAT GREEN
FLASHING Satellite data OK, will be sent, when BT connection is established.
RED OFF No charger connected
RED ON Charger connected
LED2
Akku RED FLASHING Battery is empty, unit will switch OFF soon.
BLUE OFF Unit is switched OFF
BLUE ON Unit is switched ON, ready for Bluetooth Connection
LED3
BT BLUE FLASHING Bluetooth connection successfully established
Please press the ON/OFF button for at
least 2 seconds to switch the unit ON.
If the red LED light is illuminated during
switching ON the unit, the battery has to
be charged.

User’s Manual XAiOX InstantFix Bluetooth GPS Receiver - 8 –
4. Important Notes
USB-Connector
The USB-Connector of the GPS-Unit is only for charging purpose and not for data transfer.
Car-Charger
On the tip of the car charger plug there is a removable cap. Behind is a 1.5A fuse. In
case of malfunction please check the fuse and maybe replace it.
Installation of the Bluetooth GPS to your mobile devise
The following installation instruction is based on HP iPaq. The shows installation screen
may be different with other models of PDA, Pocket-PC, etc.
Due to the high variety of mobile devices we cannot show all of them in detail.
For further more detailed instructions, please refer to the user manual of your mobile
devise.

User’s Manual XAiOX InstantFix Bluetooth GPS Receiver - 9 –
5. Box Contents
•XAiOX InstantFix Bluetooth GPS
Receiver
•220V/110V AC Adapter (Output
5V/500mA)
•Car charger (Input12V, Output 5V)
•1000mA Lithium Ion Battery
•User’s Manual (CD-ROM)

User’s Manual XAiOX InstantFix Bluetooth GPS Receiver - 10 –
5. Software Installation – Pocket PC CE
Example: iPAQ Bluetooth with Pocket PC Software
<1> Turn Bluetooth ON
Select ‚Bluetooth Manager’
<2> Click ‚Connect!’

User’s Manual XAiOX InstantFix Bluetooth GPS Receiver - 11 –
<3> Select ‚Explore a Bluetooth device’
Then click ‘Next’.
<4> Select <No device selected>,
then click ‚Next’.

User’s Manual XAiOX InstantFix Bluetooth GPS Receiver - 12 –
<5> Click ‚BT-GPS’ .
If you are asked to enter a
password, type ‚0000’.
<6> Select ‚SPP slave’,
then click ‚Next’.

User’s Manual XAiOX InstantFix Bluetooth GPS Receiver - 13 –
<7> Click ‚Finish’.
BT-GPS connection is now
established successfully.
<8> Tap the Bluetooth icon again and
select ‘Bluetooth setting’.

User’s Manual XAiOX InstantFix Bluetooth GPS Receiver - 14 –
<9> Settings for TomTom Navigation
Software. You can use any free
Serial COM Port (outgoing)