Yatin 8057007 User manual

INSTALLATION
INSTRUCTIONS
Wall-mounted single-lever
basin mixer
●We recommend that this product is installed by a qualified professional contractor.
●Please check this product immediately to ensure that it has not been damaged and is complete. Before installation, please make
sure this product is the correct model and you have all the parts required for installation and using.
●Please flush the water system to ensure that no metal swarf, solder, and other impurities can enter the taps.
●
Turn off water supply before commencing work, this should be done at the isolating valves of inlet feeds if fitted or main sto pcock.
●Please read these instructions carefully and keep it for future reference.
Maintainance
We do NOT recommend you use any household cleaners to clean the product. Because these cleaners change substance or formula
too frequently. The product should be always cleaned only with soapy water and rinsed with clean water and dried with a soft cloth.
Important
A
1 - 2
Cleaning
Before use: Unscrew the Aerator and allow the water to run freely for 5 minutes. Then screw the filter back in place.
Periodically: Unscrew the Aerator and remove. Rinse it with running water until any loose debris is cleared. Then replace the Aerator
and tighten.
Aerator

A
Installation
Dimensions
2 - 2
To remove the cartridge.
First shut off the water supply to the tap.
1: Pull out the cap from the handle.
2: Loosen the grub screw in handle, but do not remove it.
3: Take off the handle, unscrew the cartridge cover.
4: Using a correct size spanner unscrew the retaining nut.
5: Pull the cartridge and wash it with clean running water.
6: Dry and lightly grease the seals (only use silicone grease)
7: Replace them in turn.
ALLEN KEY
CARTRIDGE
MIXER BODY
RETAINING
NUT
CARTRIDGE COVER
GRUB SCREW
CAP
Base plate
Concealed valve
Screw
Base washer
Connector
Decorating plate
Spout
Cap
Screw
Screw Handle
Concealed valve
Plastic cover
1: Install the valve and connect the hot&cold inlet pipe.
2: Turn on the valve to check if there is any leakage.
3: Seal the wall and take the plastic cover out.
4: Put on the decorating plate, and install the spout & the handle.
125
203
218
G1/2
G1/2
100
200