YAW VR Yaw2 User manual

1 2 PLACE THE 2D ON THE ROTATION WITH THE
ARROWS FACING EACH
OTHER.THEN PUT THE
DESIGN LEGS IN PLACE.
3 4
SCREW BOTH SIDES TOGETHER AS
SHOWN ON THE DRAWING.
OPEN BOTH LOCKING MECHANISMS WHERE THE
OPEN SIGN INDICATES IT.
5 6
REMOVE THE FLAT CABLE CLAMPING STRAP
AND HANG THE FLAT CABLE BACKWARDS.
CONNECTION TEST: TURN THE SIMULATOR ON, WAIT
UNTIL IT LIGHTS UP, THEN TURN IT OFF AND CONTINUE
ASSEMBLY.
MAKE SURE THE 4 ROLLERS ARE IN PLACE.
USER GUIDE
BEFORE YOU START ASSEMBLING THE YAW2, WE SUGGEST TO ASK A FRIEND, FAMILY MEMBER OR A NEIGHBOR
FOR SOME HELP. SINCE THE PARTS ARE LARGE AND RELATIVELY HEAVY, YOU MIGHT NEED SOME ASSISTANCE.
REMOVE ALL THE LABELS AFTER THE RELEVANT STEP IS FINISHED.
REMOVE THE
FASTENING STRIPS
FROM THE ROTATION,
THEN THE TAPE
PROTECTING THE
CONNECTOR ON THE
BOTTOM OF THE 2D.
1 / 4
SKIP THIS STEP IF YOU DON’T HAVE
THE ROTATION PLATFORM.
SKIP THIS STEP IF YOU DON’T HAVE
THE ROTATION PLATFORM!
SKIP THIS STEP IF YOU DON’T HAVE
THE ROTATION PLATFORM.
IF THE ROLLERS FELL
OUT, PUT THEM IN THE
COMPARTMENTS CLOSER
TO THE EDGES OF THE
DEVICE

87
910
CONNECT THE FLAT CABLE AND MOUNT THE
METAL SHEET (IT'S IN THE HARDWARE PACK)
11 12 MOUNT THE SIDE RAIL ON THE ROLL (OPTIONAL, STEP
"A1"). THEN MOUNT THE ROLL ON THE ROLL ARC SO
THAT THE "FRONT" SIGNS ARE ALIGNED TO EACH OTHER.
SCREW TOGETHER AS SHOWN IN THE PICTURE
PLACE THE PITCH ON TOP AND MOVE IT
BACK & FORTH, THEN CLOSE THE
LOCKING MECHANISMS WHICH WERE
OPENED IN STEP 4..
SUPPORT THE PITCH WITH THE
SUPPORT PLASTIC.
AT THE FRONT SIGN, PUSH IT
BACKWARDS AND THEN PLACE
THE SUPPORT ON THE 2D TO
HOLD THE PITCH
SCREW ON THE
PITCH DOOR (IT'S IN
THE HARDWARE
PACK)
THEN YOU CAN
REMOVE THE
SUPPORT PLASTIC
FROM STEP 8
INSERT THE ROLL ARC INTO THE PITCH,
ACCORDING TO THE ARROWS WHILE
PUSHING THE TOP OF THE
ROLL ARC CONTINUOUSLY
TOWARDS THE BACK OF
THE PITCH.
THEN INSTALL THE
BUMPERS ON THE
OTHER SIDE OF THE
ROLL ARC
2 / 4

16
13 14
15 SLIDE THE SEAT INTO PLACE AND SECURE WITH
THE 6X50 HEX HEAD BOLT IN THE FRONT.
17 18
PULL THE CABLES COMING OUT OF THE PITCH
THROUGH THE HOLES ON THE TOP OF THE
ROLL. INSERT THE CENTRAL SHAFT OF THE
ROLL INTO THE HOLE ON THE TOP OF THE
ROLL AND SCREW IT TOGETHER.
MOUNT THE SEAT ADAPTER TO THE BOTTOM OF
THE SEAT
MOUNT THE FOOTHOLDER ON THE FOOTREST
PUSH THE ROLL IN THE RIGHT
DIRECTION AND UNSCREW THE BOLT
HOLDING THE FOOTREST, THEN
REPEAT IN THE OTHER DIRECTION.
3 / 4
SLIDE THE FOOTREST INTO
PLACE, LOOSELY TIGHTEN THE
BOLTS, THEN SIT IN THE SEAT
AND PLACE YOUR FEET IN A
COMFORTABLE POSITION AT
THE PREFERRED LENGTH.
THEN TIGHTEN
THE BOLTS
HOLDING THE
FOOTREST.