York MEVU Troubleshooting guide
MEVU
Wall Mount Adapter
Revised: 08/24/15OPERATION & MAINTENANCE
The information contained herein is, to the best of our knowledge, accurate and applicable for proper operation and installation of
the specied equipment at the time this document entered service. Before proceeding, it is recommended that you check for a more
current version of this Installation Operation Manual (IOM) on our website at www.johnsoncontrols.com.
Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by
observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain
instructions for future reference.
IMPORTANT!
READ BEFORE PROCEEDING!
JOHNSON CONTROLS2
INSTALLATION
P.O. Box 1592, York, Pennsylvania USA 17405-1592
Copyright © by Johnson Controls 2015
Revised: 08/24/15
Tele. 800-861-1001
www.york.com
For Product Warranty Support and Parts call 814-479-4005
Subject to change without notice. Printed in USA
ALL RIGHTS RESERVED
DRAIN SPOUT FACES DOWN
INSTALL BOLTS FROM INSIDE ON TOP
ANGLE TO HANG WALL ADAPTER
SOME MODELS DO NOT
CONTAIN COOLING TUBE
(EVU8 THRU 11, 13, 16 DIRECT DRIVE)
(ALL OTHER SIZES)
1. Locate top side of adapter for each size listed below.
2. Install bolts threads up on top side.
3. Apply gasket to surface as shown.
4. Attach adapter securely to wall. (Fasteners not included.
Depending on wall construction, this is to be attached at
discretion of the installer.)
5. Hang fan from top bolts as shown; secure to wall adapter
with remaining bolts.
