Zen Space Desks 1343 User manual

ZEN SPACE DESKS
SINGLE SCREEN MONITOR ARM SETUP INSTRUCTIONS
MODEL NUMBER #1343
DESK MOUNTING OPTIONS
DESK CLAMP
THROUGH DESK
Scan to watch our set-up video
Desk thickness
range
≤ 50mm
Desk thickness
range:10~50mm
Hole size ≥ 8.5mm

1 2
3 4
5
6
ASSEMBLY
Zen Space Desks Pty. Ltd.
Unit 1, 238 Lytton Rd
Morningside, Queensland 4170
Phone: [phone]
www.zenspacedesks.com.au
Ⅰ
Ⅱ
Ⅲ
ⅠⅡⅢ
Keep extra 40-50mm
length in the joint
Lay your monitor face down and align the VESA plate
with the arrow pointing towards the top of your screen
and x using the screws provided and a phillips head
screwdriver.
Conceal your cables inside the monitor arm by removing the covers and threading the
cables through. Replace the covers for tidy cables!
Clip your monitor
into the quick-release
head to secure

SETUP
1 2
3 4
Recommended
Adjustment
Set desired screen angle and
tighten as shown below
Optional Adjustment
Increase friction of movement
by tightening the below grub
screws using tools required.
Removing Your Screen From Arm
All our monitor arms come with a quick release
bracket. To remove, simply pull the tab as
shown below and lift your monitor out of the
arm.
Optional Adjustment
This arm is designed to suit monitors
between 2-10kg.
Once your monitor is xed to the arm you may
need to adjust vertical tension depending on the
weight of your screen.
• Turn clockwise to reduce tension
• Turn anti clockwise to increase tension
Only make these adjustments if your monitor raises
or lowers once xed to the arm. Watch our assembly
video for more info.