OPERATING YOUR TV
BASIC TV OPERATIONS
Selecting Channels by Using CHANNEL (CH) Up/Down
(All Models): You may select a channel through channel scan-
ningby using CHANNEL (CH) Up/Down. Only channels
stored in the channel scan sequence can be selected.
Selecting Channels by Using Numbers on Remote (Select
Models): Press the numbers corresponding to the channel
desired, then press ENTER (ENT). Any channel in the
band chosen can be selected through direct number entry.
FLSHBK (Flashback) on Remote (Select Models): Press
FI._HBK to return to the last TV channel you were watch-
ing.
Adjusting Volume (All Models): You can adjust the volume
of your TV by using VOLUME (VOL) Up/Down.
Muting Volume (Select Models): To mute the sound com-
ing from your TV, press MUTE on the remote control. To
restore sound, press MUTE again.
After an Extended Power Outage (All Models): If you pre-
viously used AUTO CH. SEARCH, you do not have to use
it again unless you permanently changed the connections to
the TV. All of the channels previously found are stored in
protected memory, and are not affected by a power outage.
However, the clock must be reset to the current time.
r
CH2
10".56
J
Channel/Time Display
CH2
10:56
MUTED
J
Channe!/Time Display
While TV is Muted
F
VOL
Volume Display * J
MUTED
Mute Display *
* VOL or MUTE display is shown only
when captions are not being displayed.
EARPHONE JACK (Select Models)
The earphone jack is used to connect a private listening ear-
phone (optional item) to your TV set. When the earphone
is plugged in, the TV speaker is turned off. This permits you
to enjoy TV programs without disturbing others in the area.
Any earphone having an 8-ohm impedance and terminated
in a 3.5mm (1/8") subminiature plug may be used. You may
purchase an earphone from your dealer.
CAUTION: When using the earphone, we suggest that you
set the volume on the TV to a low level before putting the
earphone in your ear. Then adjust the volume to a comfort-
able listening level.
SLEEP TIMER (Select Models)
Some remote controls are equipped with a TIMER button
that provides access to the SLEEP TIMER available with
some TV models. By using the SLEEP TIMER, you can
program the TV to automatically shut off after a 15 minute
period up to 4 hours.
To Set SLEEP TIMER
1. Press TIMER to see status display.
2. Press TIMER repeatedly until you reach desired
shut-off time.
One minute before the TV shuts off, the GOOD NIGHT
display appears on the screen. At this time you have a
choice of the following three actions.
1. Do nothing. The TV will shut off in one minute.
2. Remove the GOOD NIGHT display by pressing
ENTER (ENT). The TV will still shut off in one
minute.
3. Delay the shut off by using TIMER to select a new
shut off time.
To Cancel the SLEEP TIMER
You can cancel the SLEEP TIMER by setting the SLEEP
TIMER status to OFF.
NOTE: The SLEEP TIMER resets to OFF when you turn
off the TV.
SLEEP TIMER
0:15
PRESS TIMER
KEY TO CHANGE
J
Sleep Timer Display
GOOD NIGHT
"Good Night" Display
Z57_A 3 -- 1
