Zomodo FTC015 Installation instructions

ZOMODO.CA
Faucet Installation

Care and Maintenance
In order to ensure proper funcon over the lifeme of the faucet, smoothly
operate the handle and during use. When installing do not over ghten the
locking nut. Regularly clean the faucet with a so, damp cloth and avoid
abrasive cleaners, steel wool, and strong chemicals.
Notes
All pipework must be thoroughly flushed prior to installaon as foreign
materials may block the flow.
1.
Working Specificaons
Working pressure: 20-100 psi
Working temperature: 1-60°C
This faucet must be installed with isolang/wall valves in accordance with
local installaon codes. All ZOMODO faucets are strongly recommended
to be installed by a licensed plumber. Improper installaon may void the
warranty.
FTC015FTC015
Parts List
4 Faucet body
2 Ring
3 O-ring
1 Spout
5 Cartridge
6 Handle
7 O-ring
9 Plasc washer
10 Steel washer
11 Locking Nut
8 Threaded tube
13 Washer
14 Filter connector
12 Converter
1
2
3
4
7
9
10
11
8
5
6
12
13
14
116.5
207
262

FTC015FTC015
Insert the faucet into the countertop. Then
slide the washers (9 and 10) onto the threaded
tube (8) of the faucet followed by the nut (11)
in the order shown in the diagram. Tighten the
nut (11) with a wrench and ensure the faucet is
correctly aligned above the countertop.
Step 3
Tighten the converter (12) and filter
connector (14) with a wrench, ensure
washer (13) is between the converter (12)
and filter connector (14). Then connect filter
hose to the filter connector(14).
Step 4
SINK WALL
WALL
Remove the Filter connector (14), disassemble
other parts in sequence (9) (10) (11) (12) (13).
Ensure threaded tube (8) is ght in the faucet
body (4).
Step 1
Locate a hole centre in the countertop at
least 50mm from the wall and with enough
clearance to the rim/flange of the sink.
Dim. A >50mm(2”) and Dim. B >50mm (2”) .
If you need to locate the faucet within these
dimensions, you should ensure enough
clearance for the mounng washers and
nut (9,10,11). Cut a hole 26mm diameter
into the countertop .
Step 2
SINK WALL
WALL
A
B
SINK WALL
WALL
(1”)

SINK WALL
WALL
Test the faucet flow funcons, clean the
water purificaon equipment.
Step 5
FTC015
Troubleshoong
1. If water is leaking from the threaded tube (8) you should ensure the
O-ring (7) is secure in the groove of the faucet body and reghten. It
is possible that these connecons have loosened when the flexible
hoses are ghtened to the threaded tube.
2. If the faucet is lose or rotatable at the base as it enters the countertop
you should reghten the nut (11) ensuring the handle lever assembly
is correctly posioned.