ZURN MS-2620 User manual

MS-2620
MULTI-PURPOSE SINK
SINK ASSEMBLY ILLUSTRATIONS
ZURN LIGHT COMMERCIAL PLUMBING PRODUCTS 2855 GIRTS ROAD, JAMESTOWN, NY 14701
PHONE: [phone] FAX: [phone] W rld Wide Web: www.zurn.c m
DWG. NO. JS54
REV.
PRODUCT NO. MS-
DATE: 4/3/02 C.N. NO. 89103
No. Suffix Description
1 -F Floor Mounted Multi Purpose Sink
2 -PL Polyethylene Legs with leveling devices
3 -DF1 Dual Handle Deck Faucet
-AP Accessory Package*
* (-AP) Accessory
Package consists of the
following:
(1) Drying Rack
(2) Towel Bars
(1) Bottle Hol er
(1) P-trap kit.
Instructions:
Set laundry tub upside down on a
clean, smooth surface, this will help
prevent any damage to the tub rim.
Insert legs into corner sockets as
shown above. A wood block can be
used if needed. urn tub right-side
up and adjust the provided leveling
stubs to desired height. ub can now
be put in place, leveled, and water
supply connections added in accor-
dance with local water code require-
ments.

MS-2620-W Wall-Mounted
Laundry Tub Assembly
Instructions
Set the wall-mount bracket against the wall, making sure it
is level, and mark the hole positions. The holes will be 2 ½
below the top of the back of the tub. Drill the four holes for
the  diameter anchor inserts (A). Push the plastic
anchors into the holes in the wall. Make sure the wall is
of a material that is sufficient to hold the anchors once the tub
is attached and full of water. Concrete walls are recommended.
If the wall is not concrete, the floor-mounted model (MS-2620-F)
is recommended. Mount the bracket to the wall using the four
#12 x 1  phillips pan head bracket screws (B).
Attach the filler plates to the back of the tub as shown. The tongue
on top of the filler plate should fit into the groove under the backside
of the tub. The attachment pins on the bottom of the filler plates will
align with the holes in the tub. Note that there is a left and right filler plate.
If they are not used on the correct side the pins will not align with the
holes. The filler plate may need to be tapped with a hammer to
push the pin into the hole completely.
Hang the backside of the tub on the tapered top of the
bracket so that the tub is centered on the bracket. Align
the remaining two holes in the bracket with the two plastic
bosses on the underside of the back of the tub. Attach
the tub to the bracket using the two #8 x 5/8 phillips
button head screws. This must be done from the underside
of the tub.
ZURN LIGHT COMMERCIAL PLUMBING PRODUCTS 2855 GIRTS ROAD, JAMESTOWN, NY 14701
PHONE: [phone] FAX: [phone] W rld Wide Web: www.zurn.c m
DWG. NO. JS54
REV.
PRODUCT NO. MS-
DATE: 4/3/02 C.N. NO. 89103
Warranty
No warranty is implied or given. Zurn Light Commercial shall not be responsible for any labor
charges or any loss, injury or damages whatsoever, including incidental or consequential
damages. Zurn Light Commercial agrees to repair or replace any part or parts which e amination,
by an authorized Zurn Light Commercial representative, proves to be defective in workmanship or
material, within one year from date of purchase. This guarantee does not include the repair or
replacement required because of misuse, abuse, or e cessive wear and tear. Repairs made by
anyone other that a designated representative relieves Zurn Light Commercial of further liability
under this guarantee.