3idee HP-HP24F User manual

www.3idee.eu
Instruction manual
The VESA adapter is compatible with the following
products from hp: 24f, 22f, 27f, 22fw, 24fw, 27fw.
The VESA adapter allows you to conveniently mount your
HP brand monitor to a monitor arm with a VESA hole
pattern (75 x 75mm). Use the included screws and nuts for
this purpose.
If you want to mount your VESA adapter directly to the
wall, use suitable screws and dowels for this purpose. (not
included in the scope of delivery)
HP – HP24F

Assembly instruction
Step 1:
Remove the base of your monitor.
Step 2:
Mount the adapter on the VESA connector of your monitor arm or on the wall. (Figure 1).
Step 3:
Plug the monitor onto the adapter so that it audibly clicks into place.
Note: Apply a little pressure if necessary!
Figure 1
2
Instruction manual

Feel free to send your questions to:
[email protected]
Feel free to give us a call:
[phone]
You still have
questions?
Mail
Tel
Safety instructions
General Notes:
Material Notes:
– Make sure all screws are tight and the
monitor audibly clicks into place during
installation.
– The material of the adapter is not heat
resistant. Avoid direct heat in the vicinity of
the adapter, such as PC exhaust air or direct
sunlight.
The adapter is made of high quality
polylactide (PLA) plastic. PLA is both a
colorfast and UV-resistant material and
has low ammability. Polylactide has a low
temperature resistance of about 45°C-55°C
and is therefore not suitable for use around
direct heat and heat sources.
– Avoid jerky movements (pulling, tearing)
on the PC monitor. This can impair the
performance of the VESA adapter.
– Do not subject the PC monitor to
excessive loads such as leaning or pushing.
This may aect the performance of the
VESA adapter.
We wish you a lot of fun with your product.
Your 3idee Team
3idee SARL
19, Rue de Bitbourg
LU-1273 Luxembourg
3Instruction manual