3idee hp-q User manual

www.3idee.eu
hp-q VESA Adapter
Assembly instructions
The VESA adapter is compatible with the following products from hp (hp.com):
27q.
The VESA adapter allows you to conveniently mount your HP brand monitor to a
monitor arm with a VESA hole pattern (75 x 75mm). Use the included screws and
nuts for this purpose.
If you want to mount your VESA adapter directly to the wall, use suitable screws
and dowels (not included).

2
Assembly instructions
Assembly instruction
Step 1
Remove the base of your monitor.
Step 2
Before we start: It is important that you pay attention to
the correct order of the long mounting screw. First slide the
spring washer (write with slot) and then the normal washer
onto the screw. (Figure 1)
Figure 1
Step 3
Insert the adapter into the screen and fix it with the long
screw. (Figure 2)
Figure 2
Step 4
Make sure that the screw is properly tightened and no longer
protrudes.
Attention: Tighten the screw with feeling! The plastic
could otherwise break
(Figure 3)
Figure 3

3Assembly instructions
Step 5
Mount the adapter on the VESA monitor arm or directly on
the wall.
Attention: Tighten the screw with feeling! The plastic
could otherwise break
(Figure 4)
Figure 4

4
Assembly instructions
Safety instructions
General notes
Make sure that all screws are tight and that the monitor audibly clicks into place during installation (if
available).
The material of the adapter is not heat resistant. Avoid direct heat around the adapter such as PC
exhaust or direct sunlight in summer.
PLA is UV resistant but not suitable for high temperatures.
Avoid jerky movements (pulling, tearing) on the PC monitor. This can affect the performance of the
VESA adapter.
Do not subject the PC monitor to excessive loads such as leaning or pushing. This can impair the
performance of the VESA adapter.
Material Notes
The adapter is made of high-quality polylactide (PLA) plastic. PLA is both a colorfast and UV-resistant
material and has low flammability. Polylactide has a low temperature resistance of approx. 45°C-55°C
and is therefore not suitable for use in the vicinity of direct heat and heat sources.
We wish you a lot of fun with your product.
Your 3idee Team
Responsible for this content:
3idee Technologies S.à r.l
5, ZA Um Lenster Bierg
L-6125 Junglinster
Luxembourg
Powered by TCPDF (www.tcpdf.org)