3M XM-8635 User manual

pproduct name
Weather forecast module p
product model
XM-8635
Renderings
actual picture

II. Technical specifications
project performance parameter
operating voltage DC12-24V
incoming current 200ma(Max)
screen size 86mm*35mm(（L*W)
Second, the job description
Operating instructions:
1. Use with touch switch
2. Use with touch switch

 YI U ,- g 6`7t F8 JK rxyhu.  !iaLb9 j
"ZJ#V :k M Blv G; /0NOmb n < $o_s[=>1 c+^
%ZJ&W 7 EPd e2 'YL(X QeRzF p 3O{r\ C?w
H@ |)*A}~D] 45STqf

%O,4Iy
 
CRS_5yFGy&P2y6Qf7X'`alTY3
t!$Hn
y



 
"ym8(gD9Zy@W:-)bhyKy 

$ $ $ $ $ #"
$ $ $ $ $ $ $ $  

$ $ $ $ $ $ $ $ $
$ $ $ $ $ $ $

  

 vus pwx.cy y

#y ;*iE<[yAUq=/+djLB\]y r

oy J

MVN?g^0e1k>y





!$

IIII. Screen display:

IIV. Product wiring diagram:
Touch switch wiring diagram
Touch switch wiring diagram
V. Laser marking map

VVI. Installation Steps

F
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user's authority to operate
the equipment.