A & T International E5812B User manual

Quick start guide
E5812B/E5813B/E5814B/
E1812B/E1813B/E1814B
5.8 GHz cordless telephone/
answering system with
caller ID/call waiting

Choose a central location close to a telephone jack and a power outlet not
connected to a wall switch. The telephone base can be placed on a flat sur-
face or mounted on a standard wall plate. For optimum range and better
reception, place the telephone base in a high and open location.
Avoid placing the telephone base too close to:
• Communication devices such as: personal computers, computer routers, tel-
evision sets, VCRs, wireless routers (wireless broadband, wi-fi, or 802.11) or
other cordless telephones.
• Excessive heat sources.
• Noise sources such as a window with traffic outside, motors, microwave ovens,
refrigerators, or fluorescent lighting.
• Excessive dust sources such as a workshop or garage.
• Excessive moisture.
• Extremely low temperature.
• Mechanical vibration or shock such as on top of the washing machine or
work bench.
Battery installation & charging
After installing the battery, you may be able to make or receive short calls. For
best performance, place the handset in the telephone base or charger to charge
for 16 hours before use.
You can keep the battery charged by returning the handset to the telephone
base or charger after use. When the battery is fully depleted, a recharge takes
about 12 hours. The average talk time on a fully charged battery is about five
hours, and the standby time is approximately six days. Actual battery life depends
on usage conditions and age of battery.
1. Insert the plug as indicated. Be sure to
securely insert the plug, making sure that
it matches the color-coded label inside the
battery compartment.
2. Place the battery and wires inside the com-
partment.
3. Slide the battery compartment cover up until
it clicks.
NOTE: Under normal conditions, the bat-
tery should last around one year. This may vary
depending on usage.
1
23
Caution: Use only the supplied rechargeable battery, replacement battery 2422 (SKU 23402, part
number 89-0047-00-00) or equivalent. To order a replacement battery, visit our
website at www.telephones.att.com or call 1 [phone]. In
Canada dial 1 [phone].

Telephone base installation
NOTES:
1. Use only the power adapter supplied with this product or equivalent. To order a replace-
ment power adapter, visit our website at www.telephones.att.com
or call 1 [phone]. In Canada dial 1 [phone].
2. Be sure to use an electrical outlet not controlled by a wall switch.
3. This power adapter is intended to be correctly oriented in a vertical or floor mount position.
4. If you receive high speed internet through your telephone line (commonly referred to as DSL), and
you are experiencing interference during telephone conversations and/or your caller ID features
are not functioning properly, install a DSL filter to the telephone line between the telephone base
and the telephone wall jack. Contact your DSL service provider for a DSL filter.
8. You may be able to
make or receive short
calls. For best perform-
ance, place the handset
in the telephone base
to charge for at least 16
hours before first use.
6. Plug the small end of
the smaller power adapter
into the jack on the under-
side of the charger, then
route the cord through the
slot as shown.
7. Plug the large
end of the smaller
power adapter into
an electrical outlet
not controlled by a
wall switch.
Telephone line cord
DSL filter
(Optional for DSL users, see
number four in the note
section, below.)
5. Plug the other end of the telephone
line cord into a telephone jack.
4. Plug the large end of
the larger power adapter
into an electrical outlet
not controlled by a wall
switch.
3. Route cords through
slots.
1.Plug the small end of the larger
power adapter into the power jack at
the bottom of the telephone base.
2.Plug the end of the telephone line
cord into the telephone jack at the
bottom of the telephone base.

DIR /VOLUME +
While in a menu, press to scoll up.
When in idle mode, press to dis-
play directory entries. While enter-
ing names, press to advance the
cursor. During a call, press DIR to
increase listening volume.
NOTE: For more information, please refer to the user's manual.
Quick reference guide
Cordless handset
SPEAKER
Press to activate handset speak-
erphone. Press again to resume
normal handset use.
CHAN/DELETE
When on a call, press CHAN/DELETE
to scan for a clearer channel when
there is static or interference on
the line. When in caller ID mode,
press to delete the displayed call-
er ID entry, or press and hold to
delete all caller ID entries.
PHONE/FLASH
Press to make or answer a call.
During a call, press to receive
an incoming call if call waiting is
activated.
MENU/SEL/TRANSFER
Press to display a menu or to con-
firm a command. During a call,
press to transfer a call between
handsets.
OFF/CLEAR
During a call, press to hang up.
While using menus, press to
cancel an operation, or exit the
menu.
REDIAL/PAUSE
While in idle mode, press to display
last number called. While dialing or
entering numbers to the directory,
press to insert a four-second dial-
ing pause.
CID/ -VOLUME
While in a menu, press to scoll
down. When in idle mode, press
to display call summary entries.
While entering names or num-
bers, press to move the cursor to
the left. During a call, press CID
to decrease listening volume.
Feature menu
Feature menu
DIRECTORY
SPEED DIAL
RINGER
DATE/TIME
DIAL MODE
LANGUAGE
DIRECTORY
MUTE
While on a call, press to mute
microphone. Press again to resume.
Using menus
Press CID or DIR to scroll through
menu items.
Press MENU/SEL to select or modify a
highlighted item.
Press OFF/CLEAR to cancel an oper-
ation, or exit the menu display.

NOTE: For more information, please refer to the user's manual.
SKIP
Quick reference guide
Telephone base
Press to review or change
answering system options.
Press to delete message
currently playing; press and
hold to delete all old mes-
sages.
Press to review or record
announcement; press
again to quit.
Press to record a memo
or after pressing ANNC.
to record an outgoing
announcement.
Press to turn answering
system on or off.
Press to repeat message;
press twice to play previous
message.
Press to start or stop mes-
sage playback.
Press to adjust playback
volume.
Press to skip message.
VOLUME
ANSWER ON
RECORD
DELETE
PLAY/STOP
ANNC.
CLOCK
REPEAT
Press to review or set clock.
SETUP
Number of messages (or
during playback, message
number currently playing).
MESSAGE COUNTER
CHARGE/IN USE
• Flashes when one of the
handsets is in use.
• Flashes when the answer-
ing system is answering an
incoming call.
• Flashes quickly while an
incoming call is ringing.
• On steady when the hand-
set is properly positioned to
charge in the telephone base.
HANDSET LOCATOR
Press to make the handsets
beep when there is no hand-
set on the telephone base.

www.telephones.att.com
© 2007 Advanced American Telephones. All rights reserved.
AT&T and the AT&T logo are trademarks of AT&T Knowledge Ventures,
licensed to Advanced American Telephones. Printed in China. Issue 5 AT&T 06/07.
96-006296-030-100