A-Eco Living HDPE Balcony Table User manual

Assembly Instruction
Pls visit our website at A‐ecoliving.com for more care and maintenance tips.
Claims contact information, please email all claims to Support@A‐ecoliving.com
HDPE Balcony Table
Your furniture requires assembly prior to use. It is important that you read the entire assembly instructions
to become familiar with the unit before you set up this product.
Safety Warning and Precautions
WARNING: When setting up your furniture, basic precautions should always be followed to reduce risk of
personal injury and damage to the product.
Read all instructions before assembly and usage this product.
1. Select ideal location. Set out all parts on a clear and level surface prior to assembly. Ideally, the furniture
should be set up in the desired location to avoid moving it after assembly.
2. Use caution. During all the processes of assembling, especially when lifting heavy or large parts, pay
attention to safety.
3. Tools and Assistance. An adjustable spanner is required for assembly. It is recommended 2 people assist
with assembly.
4. Check all parts before assembling, ensure you have all parts detailed in the parts list on Page 2.
5. Refer to assembly diagram. During assembly, refer to the assembly instructions on following pages.
6. Caution. Keep children away from work area during assembly. Do not allow children to handle parts or
tools while assembling.

Assembly Instruction
Pls visit our website at A‐ecoliving.com for more care and maintenance tips.
Claims contact information, please email all claims to Support@A‐ecoliving.com
HDPE Balcony Table
PANEL AND FITTINGS IDENTIFICATION
Part #
A
B
C
D
E
Z1
Description:
Rod
Table Leg
Table Top
Screw M6*65
Bolt M6*65
Allen Wrench
M5
Figure:
Qty:
4
2
1
8
6
1
Part #
Z2
Description:
Allen Wrench
M4
Figure:
Qty:
1

Assembly Instruction
Pls visit our website at A‐ecoliving.com for more care and maintenance tips.
Claims contact information, please email all claims to Support@A‐ecoliving.com
HDPE Balcony Table
Steps:
1. Attach the Rods (Part A) to the Table Legs (Part B) with Screws M6*65 (Part D) by using Allen Wrench M5 (Part Z1).
2. Attach the Table Legs (Part B) to the Table Top (Part C) with Bolt M6*65 (Part E) by using Allen Wrench M4 (Part Z2).
Tighten all screws. Your chair is ready to use. (Note: All screws shall be loose‐fitted to corresponding holes and then tighten them
together.)
Periodically check and make sure that all screws are fully tightened.