A1 Security Cameras VZ-WM11 User manual

VZ-WM11
Display 10”~24”
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]

Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
NOTE: Read the entire instruction manual before you start installation and assembly.
WARNING
• Do not begin the installation until you have read and understood all the instructions
and warnings contained in this installation sheet. If you have any questions
regarding any of the instructions or warnings, please contact your local distributor.
• This mounting bracket was designed to be installed and utilised ONLY as
specified in this manual. Improper installation of this product may cause damage
or serious injury.
• This product should only be installed by someone with good mechanical ability
who has basic building experience and fully understands this manual.
• Make sure that the supporting surface will safely support the combined weight of
the equipment and all attached hardware and components.
• If mounting to wood wall studs, make sure that mounting screws are anchored
into the center of the studs. The use of a stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position
the equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can cause damage
to the items, This greatly reduces their holding power.
• This product is intended for indoor use only. Using this product outdoors could
lead to product failure and personal injury.
Component Checklist
IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installation.
If any parts are missing or faulty, telephone your local distributor for a replacement.
wall mount (x1)
A
wrench (x1)
B
Package M
M4x14 (x4)
M-A
Package W
M6x30 (x2)
W-A
iron expansion bolt (x2)
W-B
2 1

Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
1a. For Wood Stud Wall Mounting 1b. For Solid Brick and Concrete Mounting
55mm55mm30mm 60mm60mm60mm
(((221...222"""))) (((222...444""")))
ø 4.5mm ø 10mm
(ø 3/16") (ø 3/8")
12 1
Find and mark the exact Mark the exact
location of mounting holes location of
mounting holes
3
2
Drill pilot holes
Drill pilot holes
√X X √X X
XX
W-A
W-B
Screw the wall
mount onto
the wall Screw the wall
mount onto
the wall
WARNING
• Make sure that mounting screws are anchored into the center of the studs. The use of a stud
finder is highly recommended. WARNING
• Installers are responsible to provide hardware for other types of mounting situations.
Installers must verify that the supporting surface will safely support the combined weight of
• Installers must verify that the supporting surface will safely support the combined weight of the the equipment and all attached hardware and components.
equipment and all attached hardware and components.
3 4

Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
M-A
2. Attaching the Display to the VESA Plate 3. Adjustment
TV TV B
TV
Tension is pre-set at the factory. If too tight or too
loose, you may adjust the tension by loosening or
tightening the head and arm adjustment bolts.
+45°
180°
±180°
-45°
Lift the display and match the holes on your display with the holes on the mount. Secure your display to
the mount by tightening screws.
Tighten all screws but do not over tighten.
Adjust to the desired position or tilt.
Maintenance
• Check that the bracket is secure and safe to use at regular intervals(at least every three months).
• Please contact your dealer if you have any questions.
6 5